Schaub Lorenz SLK MY6SC1 - Инструкция по эксплуатации - Страница 36

Turn On and Turn Off The Appliance

If the appliance is in 

Stand-By-Mode, 

it is put in 

Operating-Mode

 by pressing

the 

On/Off

 button       at least 1 second. A buzzer signal indicates the

successful operation acoustically.

On all heaters a ´0` appears and all 

Decimal Point

 of the heater flashes (1

sec on, 1 sec off).

If there is no operation within 10 sec, the display of all heaters will turn off.

If the displays are turned off, the heater will be set into 

Stand-By-Mode

.

If      is pressed more than 2 sec (in 

Operating-Mode

), the appliance is

switched off and is set into the 

S-Mode

 again. The appliance can be turned

off by pressing       at any time; even if other buttons are pressed

simultaneously.

If there is a residual heat of a heater remaining, this will be indicated in the

correspondent heat setting 

Heater Display

.

Select Heater

If a single heater is chosen with the corresponding 

Active/Deactive Heater

Button

       , the 

Decimal Point

 of the related 

Heater Display

 flashes. For the

selected heater, you can set the heat level between 1-9 by touching the

Heat Setting Slider Buttons

The slider button must be pressed within 3 sec, otherwise the heater selection

is erased and heat setting dot will disappear (

Decimal Point

). If there is no

further operation within 10 sec, the heater falls back into the 

S-Mode

.

The heat setting can always be changed by pressing                         between

level 1-9.

Each sliding operation or each display change is quitted by a buzzer signal.