Stiga SBC 500 AE 278200008/ST1 - Инструкция по эксплуатации - Страница 181

EN - 18

14. TROUBLESHOOTING

PROBLEM

PROBABLE CAUSE

SOLUTION

1. 

When the safety 

button is pressed, 

the two green lights 

do not come on

Battery is not inserted or 

is inserted incorrectly

Make sure the battery is inserted and 

well fit in its housing (paragraph 7.2.3)

2. 

Pushing the safety 

button, the LED 

(Fig. 7.G) blinks

Low battery

Check the battery status and 

recharge if necessary (par. 7.2.2)

3.   The motor stops during 

work and 

the LED 

 (Fig. 7.G) blinks

Low battery

Check the battery status and 

recharge if necessary (par. 7.2.2)

4. 

The cutting means is 

stationary when the 

throttle control lever 

and throttle safety 

lever are engaged

Machine damaged

Do not use the machine. Immediately 

turn off the machine remove the battery 

and contact a service centre.

5.  Motor overheating

Grass caught under the 

cutting means guard

Remove caught grass (par. 6.5)

6. 

Mowing is difficult

The cutting means is not 

in good condition

Proceed with cutting means 

maintenance (par. 8.1)

7. 

Grass accumulates 

around the rod housing 

and cutting line head

Too high grass is being cut 

close to the ground

Cut tall grass with a top down 

movement to avoid accumulations. 

8.  The line is not released 

when the cutting line 

head hits the ground

The line is stuck to itself

Lubricate with silicone spray

Not enough line on the 

reel or reel empty

Replace the line (chapter 8.1.3.)

The line is worn and too short

Pull the line while pressing the release button

The line is tangled on the reel or broken Remove the line from the reel 

and 

rewind it (chapter 8.1.3)

9. 

The cutting means 

comes into contact 

with a foreign body.

-

Turn off the machine, remove the battery and:

- inspect for damage;

- check for and tighten any loose parts;

- have all replacements or repairs carried 

out by an authorised service centre.

10.  Excessive noise and/or 

vibration is experienced 

whilst working

Loose or damaged parts.

Turn off the machine, remove the battery and:

- inspect for damage;

- check for and tighten any loose parts;

- have all replacements or repairs carried 

out by an authorised service centre.

11. 

The machine gives off 

smoke whilst working

Machine damaged

Do not use the machine. Immediately 

turn off the machine remove the battery 

and contact a service centre.

12. 

Battery power 

reserve is low

Severe working conditions 

requiring greater

current absorption

Optimise operations

(par. 7.2.1)

Battery is insufficient for 

operating requirements

Use a second battery or 

extended 

battery (par. 15.1)

Decrease in battery capacity

Purchase a new battery

If problems persist after having performed the operations described above, contact your dealer.