Триммеры Ryobi RLT430CESD 5133002546 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
English
5
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
TROUBLESHOOTING
Problem
Possible cause
Solution
Engine will not start.
No spark.
Clean or replace spark plug. Reset spark plug
gap. Refer to Spark Plug Replacement earlier in
this manual.
No fuel.
Push primer bulb until bulb is full of fuel. If bulb
does not
¿
ll, primary fuel delivery system is
blocked. Contact a service dealer. If primer bulb
¿
lls, engine may be
À
ooded, proceed to next item.
Flooded engine.
Set the start lever to the FULL CHOKE position.
Squeeze the trigger and pull the rope repeatedly
until the engine starts and runs.
NOTE: Depending on the severity of the
À
ooding,
this may require numerous pulls of the rope.
Engine does not reach
full speed.
Fuel
À
ow problem.
Squeeze and release the throttle trigger 5 times
while the engine is running.
Engine does not reach
full speed and/or emits
excessive smoke.
Air
¿
lter screen is dirty.
Clean air
¿
lter screen. Refer to Cleaning Air Filter
Screen earlier in this manual.
Spark arrestor screen is dirty.
Contact a servicing dealer.
Spark plug fouled.
Clean or replace spark plug. Reset spark plug
gap. Refer to Spark Plug Replacement earlier in
this manual.
Engine starts, runs, and
accelerates but will not idle.
Idle speed screw on carburettor
needs adjustment.
Contact a service dealer for adjustment.
String will not advance
String is welded to itself.
Replace string. Refer to the applicable string
replacement section in this manual.
Not enough string on spool.
Install more string. Refer to the applicable string
replacement section in this manual.
String is worn too short.
Pull strings while alternately pressing down on
and releasing spool retainer.
String is tangled on spool.
Remove string from spool and rewind. Refer to
the applicable string replacement section in this
manual.
Engine speed is too slow.
Advance string at full throttle.
Spool retainer hard to turn
Screw threads are dirty or
damaged.
Clean threads and lubricate with grease - if no
improvement, replace the spool retainer.
Grass wraps around
driveshaft housing and
string head
Cutting tall grass at ground level.
Cut tall grass from the top down to prevent
wrapping.
Operating trimmer at part throttle.
Operate trimmer at full throttle.
Engine emits too much
smoke
Too much oil in crankcase.
Drain lubricant and re
¿
ll with correct amount of
20W-50 engine lubricant. See Adding/Checking
Engine Lubricant in the operation section of this
manual.
