Microlife BP A150 Afib - Инструкция по эксплуатации - Страница 8

6

10. Error Messages

If an error occurs during the measurement, the measurement is 

interrupted and an error message, e.g. «

ERR 3

», is displayed.

* Please consult your doctor, if this or any other problem occurs 

repeatedly.



If you think the results are unusual, please read through the 

information in «Section 1.» carefully.

11. Safety, Care, Accuracy Test and Disposal



Safety and protection

•

This device may only be used for the purposes described in 

these instructions. The manufacturer cannot be held liable for 

damage caused by incorrect application.

•

This device comprises sensitive components and must be 

treated with caution. Observe the storage and operating condi-

tions described in the «Technical Specifications» section.

•

Protect it from:

- water and moisture

- extreme temperatures

- impact and dropping

- contamination and dust

- direct sunlight

- heat and cold

•

The cuffs are sensitive and must be handled with care.

•

Do not exchange or use any other kind of cuff or cuff connector 

for measuring with this device.

•

Only pump up the cuff once fitted.

•

Do not use this device close to strong electromagnetic fields 

such as mobile telephones or radio installations.

•

Do not use this device if you think it is damaged or notice 

anything unusual.

•

Never open this device.

•

If the device is not going to be used for a prolonged period the 

batteries should be removed.

•

Read the additional safety information provided within the indi-

vidual sections of this instruction manual.

Ensure that children do not use this device unsupervised; 

some parts are small enough to be swallowed.

Device care

Clean the device only with a soft, dry cloth.

Cleaning the cuff

Carefully remove spots on the cuff with a damp cloth and soapsuds.



WARNING: 

Do not wash the cuff in a washing machine or 

dishwasher!

Accuracy test

We recommend this device is tested for accuracy every 2 years or 

after mechanical impact (e.g. being dropped). Please contact your 

local Microlife-Service to arrange the test (see foreword).

Error

Description Potential cause and remedy

«

ERR 1

» Signal too 

weak

The pulse signals on the cuff are too 

weak. Re-position the cuff and repeat the 

measurement.*

«

ERR 2

»

AR

Error signal During the measurement, error signals 

were detected by the cuff, caused for 

instance by movement or muscle 

tension. Repeat the measurement, 

keeping your arm still.

«

ERR 3

»

AS

No pressure 

in the cuff

An adequate pressure cannot be gener-

ated in the cuff. A leak may have 

occurred. Check that the cuff is correctly 

connected and is not too loose. Replace 

the batteries if necessary. Repeat the 

measurement.

«

ERR 5

» Abnormal 

result

The measuring signals are inaccurate 

and no result can therefore be displayed. 

Read through the checklist for 

performing reliable measurements and 

then repeat the measurement.*

«

ERR 6

» AFIB/MAM 

Mode 

There were too many errors during the 

measurement in AFIB/MAM mode, 

making it impossible to obtain a final 

result. Read through the checklist for 

performing reliable measurements and 

then repeat the measurement.*

«

HI

»

Pulse or cuff 

pressure 

too high

The pressure in the cuff is too high (over 

300 mmHg) OR the pulse is too high 

(over 200 beats per minute). Relax for 5 

minutes and repeat the measurement.*

«

LO

»

Pulse too 

low

The pulse is too low (less than 40 beats 

per minute). Repeat the measurement.*