Stanley SCD20S2K - Инструкция по эксплуатации - Страница 6

6

ENGLISH

(Original instructions)

  WARNING: Shock hazard. Do not allow any 

liquid to get inside charger. Electric shock may 

result.

  CAUTION: Burn hazard. To reduce the risk 

of injury, charge only 

STANLEY

 rechargeable 

batteries. Other types of batteries may burst 

causing personal injury and damage.

    CAUTION: Children should be supervised to 

ensure that they do not play with the appliance.

NOTICE: Under certain conditions, with the 

charger plugged in to the power supply, the 

charger can be shorted by foreign material. 

Foreign materials of a conductive nature such 

as, but not limited to, grinding dust, metal chips, 

steel wool, aluminum foil, or any buildup of 

metallic particles should be kept away from 

charger cavities. Always unplug the charger 

from the power supply when there is no battery 

pack in the cavity. Unplug charger before 

attempting to clean.

 • DO NOT attempt to charge the battery pack with any 

chargers other than the ones in this manual. The 

charger and battery pack are specifically designed to 

work together. 

 • These chargers are not intended for any uses other 

than charging STANLEY rechargeable batteries. Any 

other uses may result in risk of fire, electric shock or 

electrocution.

 • Do not expose charger to rain or snow.
 • Pull by plug rather than cord when disconnecting 

charger. This will reduce risk of damage to electric plug 

and cord.

 • Make sure that cord is located so that it will not be 

stepped on, tripped over, or otherwise subjected to 

damage or stress.

 • Do not use an extension cord unless it is absolutely 

necessary. Use of improper extension cord could result 

in risk of fire, electric shock, or electrocution.

 • Do not place any object on top of charger or place 

the charger on a soft surface that might block the 

ventilation slots and result in excessive internal 

heat. Place the charger in a position away from any heat 

source. The charger is ventilated through slots in the top 

and the bottom of the housing.

 • Do not operate charger with damaged cord or plug — 

have them replaced immediately.

 • Do not operate charger if it has received a sharp 

blow, been dropped, or otherwise damaged in any 

way. Take it to an authorised service centre.

 • Do not disassemble charger; take it to an authorised 

service centre when service or repair is required. 

Incorrect reassembly may result in a risk of electric 

shock, electrocution or fire.

  •  In case of damaged power supply cord the supply cord 

must be replaced immediately by the manufacturer, its 

service agent or similar qualified person to prevent any 

hazard.

 • Disconnect the charger from the outlet before 

attempting any cleaning. This will reduce the risk of 

electric shock. Removing the battery pack will not reduce 

this risk.

  •  NEVER attempt to connect 2 chargers together.
 • The charger is designed to operate on standard 

household electrical power. Do not attempt to use it 

on any other voltage. This does not apply to the vehicular 

charger.

SAVE THESE INSTRUCTIONS

Chargers

The SC201/ SC202 accept 18V batteries. 
These chargers require no adjustment and are designed to be 

as easy as possible to operate.

Charging Procedure (fig. 2)

  1.  Plug the charger (j) into an appropriate outlet before 

inserting battery pack. 

  2.  Insert the battery pack (g) into the charger. The red 

(charging) light will blink continuously indicating that the 

charging process has started. 

  3.  The completion of charge will be indicated by the red light 

remaining ON continuously. The pack is fully charged and 

may be used at this time or left in the charger.

NOTE: To ensure maximum performance and life of Li-Ion 

batteries, charge the battery pack fully before first use.

Charging Process

Refer the tables below for the state of charge of the battery 

pack. 
  State of charge–SC201
 

  charging 

––  ––  ––  ––   –– 

  fully charged 

–––––––––––––––––––– 

  hot/cold pack delay  ––  ––  ––     ––––––– 

HOT/COLD PACK DELAY
SC201/ SC202
When the charger detects a battery that is hot, it automatically 

delays charging until the battery has cooled.