AL-KO Easy Crush LH 2800 - Инструкция по эксплуатации - Страница 19

Maintenance and care

440558_b

19

WARNING!

Risk of injury due to revolving tools!
Revolving tools can cause severe hand

and finger injuries!
When working on the cutting tool, discon-

nect  the  machine  from  the  mains  con-

nection and wait for the tool to stop mo-

ving.

Readjusting the counterplate

To  obtain  an  optimum  shredding  result  and

prevent damage to the blade unit (7/3), the coun-

terplate (7/2) must be readjusted at regular inter-

vals.
The counterplate must also be adjusted, if so-cal-

led interlinkage occurs.
With the motor running:
1. Turn  adjusting  screw  (7/1)  1/6  revolution  to

the  right  (clockwise),  until  a  slight  friction

noise can be heard and fine aluminium chips

fall  from  the  ejector  chute  for  a  short  period

of time.

2. Now, the materials to be shredded should be

fully cut again.

Care

Remove dirt and material residues after every

use.
Do not clean the machine with running water

or high-pressure.
Do not use any cleaning agents or solvents.
Use a soft brush or cloth for cleaning.

STORAGE

Clean the shredder after its use. Store it in a dry,

lockable place out of the reach of children.
Perform  the  following  tasks  when  storing  during

the winder period:
1. Switch  off  the  machine  and  disconnect  from

the mains connection.

2. Empty the grass catcher.
3. Store the shredder vertically.

WORKING BEHAVIOUR AND WORKING

TECHNIQUE

The shredder is only partly suitable for shred-

ding  soft,  very  juicy  waste  (e.g.  pome  fruits,

wet plant waste). These materials should be

directly composted, as they quickly compact

themselves.
The  shredder  is  best  suitable  for  shredding

long-stem,  hard  or  already  dried  stems  of

flowers, shrubs, bushes and pruning.
Shred  branches  shortly  after  cutting  to

achieve optimum results.
Soft materials to be shredded should always

be  processed  alternating  with  branches  to

prevent clogging of the cutting drum.
Principally,  only  feed  materials  to  be  shred-

ded after the machine was switched on.
Feed materials to be shredded are automati-

cally pulled in.
Only feed as much materials to be shredded

to ensure that hopper and feed chute do not

clog.
Empty  the  grass  catcher  on  a  regular  base,

as overfilling can cause materials backing up

in the cutting drum.
Refer to "Transporting the shredder" for mo-

ving the shredder to a new location.

WARNING!

Risk of injury due to ejected parts!
Ejected plant parts can cause severe in-

juries!
Always  wear  personal  protective  equip-

ment when working with the shredder.

DANGER!

Risk  of  injury  and  damage  to  the  ma-

chine if used other than according to the

designated use!
Ejected parts can cause most severe in-

juries!
Do  not  feed  stones,  soil,  glass,  textiles,

plastic or metal parts into the machine.