AL-KO Easy Crush LH 2800 - Инструкция по эксплуатации - Страница 14

en

Translation of the original instructions for use

14

Easy Crush LH 2800

TRANSLATION OF THE ORIGINAL

INSTRUCTIONS FOR USE

Contents

About  this  handbook........................................ 14
Product  description.......................................... 14
Product  overview..............................................15
Safety  instructions............................................ 15
Assembly.......................................................... 17
Startup.............................................................. 17
Operation.......................................................... 17
Maintenance  and  care..................................... 18
Storage............................................................. 19
Working behaviour and working technique...... 19
Disposal............................................................ 20
Troubleshooting................................................20
EU declaration of conformity............................ 21
Warranty........................................................... 22

ABOUT THIS HANDBOOK

Read  this  documentation  before  starting  up

the  machine.  This  is  a  precondition  for  safe

working and flawless operation.
Observe  the  safety  warnings  in  this  docu-

mentation and on the product.
This  documentation  is  a  permanent  integral

part  of  the  product  described  and  must  be

passed on to the new owner if the product is

sold.

Explanation of symbols

CAUTION!

Following  these  safety  warnings  care-

fully  can  prevent  personal  injury  and/or

material damage.

ADVICE

Special  instructions  for  greater  ease  of

understanding and improved handling.

PRODUCT DESCRIPTION

This documentation describes a drum shredder.

Symbols on the machine

Important! Take particular care during

handling.

Before taking into operation, read the in-

structions for use.
Important – danger! Keep your hands and

feet away from the blade system!
Keep your hands away from the blade

system.

Keep third parties out of the danger area!

Keep distance to the danger area.

Always disconnect the machine from the

mains before maintenance or if the cable

is damaged or cut.
Wear protective glasses and ear defen-

ders.

Wear gloves.

Safety and protective equipment

DANGER!

Danger of injury if the safety devices are

tampered with!
Tampering with safety devices can result

in serious injuries!
Do  not  deactivate  safety  and  protective

devices.

Hopper concept

The  hopper  opening  was  designed  according  to

the standard to prevent reaching inside.

Motor protection switch

The  motor  protection  switch  disconnects  in  the

case  of  overload.  Hereby,  switch  (6/4)  pops  out

of  the  control  panel.  The  switch  can  be  pushed

back  in  again  after  a  cooling-down  phase  of  ap-

prox. 5 minutes, and the machine can be switched

on.  If  the  switch  does  not  remain  by  itself  in  the

pressed position, extend the cooling-down phase.

If the problem continues to exist, take the machine

to a specialist workshop.

Restarting protection

For  your  safety,  the  machine  is  fitted  with  a  0-

voltage  switch,  which  automatically  switches  the

machine  off  in  the  case  of  a  power  interruption.

Once the voltage supply is re-established, the ma-

chine  does  not  automatically  restart.  Press  the

On-switch (6/6) for restarting.