Xiaomi Mi Robot Vacuum-Mop 2 Ultra (BHR5195EU) - Инструкция по эксплуатации - Страница 8

13

14

CAUTION: 

If too much hair is tangled in the brush, or if the hair is tightly tangled, do not 

forcibly pull on it, as this could damage the brush.

Brush

* Weekly cleaning is recommended.

1. Flip the vacuum-mop over and pinch the clips to remove the brush cover.

2. Lift the brush out of the vacuum-mop, then clean the brush bearings.

3. Use the included cleaning tool to cut any tangled hairs on the brush, 

and remove the hairs and other debris from the brush.

4. Reinstall the brush and the brush cover, and ensure they are securely in 

place.

Note: 

It is recommended to clean the brush weekly and replaced every 6 to 12 months.

Brush Cover
Clips
Brush

Brush Bearings

Cleaning Tool

Care & Maintenance

Omnidirectional Wheel

* Clean it as needed.

1. Flip the vacuum-mop over and pull 

out the omnidirectional wheel.

2. Remove hair, dirt, and other debris 

from the wheel and axle.

3. Reinsert the wheel and press it firmly 

back into place.

Notes:

 ·A small screwdriver or other pry tool can be used to gently pop out and remove the 

wheel.

 ·

The wheel can be cleaned with water and reinstalled after drying.

Wheel

Axle

Side Brush

* Monthly cleaning is recommended.

1. Flip the vacuum-mop over and remove the side brush upwards to clean it.

2. Reinstall the side brush to the vacuum-mop.

Note: 

It is recommended to clean the side brush monthly and replace every 3 to 6 months.

3. To install the mopping assembly, slide it into the back of the vacuum-
mop until it clicks into place. Press the button   or use the Mi Home/

Xiaomi Home app to start the cleanup. The vacuum-mop will automatically 

recognize the mopping assembly and begin mopping and dispensing water 

as needed.

4. Remove the mopping assembly

CAUTION:

 · To prevent the vacuum-mop from entering a carpeted area, use physical barriers or set 

up virtual walls or restricted areas in the app before mopping.

 · The mop pad should be cleaned after every 30 minutes of use to ensure adequate water 

flow and cleaning effectiveness.

Note:  

When the vacuum-mop is charging or not in use, remove the mopping assembly. Pour out 

all remaining water in the tank, and clean the mop pad to prevent mildew or lingering odors.

After the vacuum-mop finishes cleaning and returns to the charging dock, press 

the side clips of the mopping assembly inward and pull to remove the assembly.

Using the Mopping Function

1. First dampen the mop pad and wring out excess water. Next, slide the 

edge of the middle part of the mop pad into the middle slot of the water 

tank, and then slide the edges on both ends of the mop pad into the slots on 

both sides of the water tank. Lastly, press the pad firmly onto the velcro to 

attach it to the water tank.

2. Open the water tank lid, fill the tank with water, then securely close the lid.

CAUTION:

 · Do not add hot water to the water tank, as this may cause the tank to become deformed.

 · To avoid clogging, do not add any cleaning agents or disinfectants to the water tank.

①

②

③

④