Roborock E452-02 - Инструкция по эксплуатации - Страница 16

① Adjust flow rate

Toggle the switch to adjust the flow rate according to your 

needs.

③ Install the mop cloth

Dampen the mop cloth and squeeze it until it stops 

dripping. Insert it into the mounting slot in the water tank.

④ Install the module

Slide the mop module in line with the alignment marks on 

the rear of the machine until you hear a "click".

Using the robot

5. Mopping

Note:

• 

It is recommended that all floors are vacuumed at least three times before the 

first mopping session to reduce excessive dirt buildup on the mop.

• 

Use barrier tape to prevent mopping carpeted areas, or remove carpets prior 

to mopping.

• 

To prevent corrosion or damage, do not use cleaning fluid or disinfectant in 

the water tank.

• 

Cleaning the mop cloth every 60 minutes is recommended to ensure the 

water flow rate and cleaning effect.

High

 Low

② Fill the water tank

Open the water tank, fill it with water, and close it tightly

Installation

12