Mi Robot Vacuum-Mop SKV4093GL - Инструкция по эксплуатации - Страница 9

Battery

Note: If the vacuum-mop is not used for an extended period, turn it off and put it away. To prevent 

damage from over-discharging, the vacuum-mop should be recharged at least once every three 

months.

The vacuum-mop contains a high-performance lithium-ion battery 

pack. Please ensure that it remains well-charged during daily use to 

maintain optimal battery performance.

Updating the Firmware

You can update the firmware via the app. Before updating, make sure 

the vacuum-mop is on the charging dock and has at least 15% battery 

left.
The power indicator of the vacuum-mop will blink quickly between 

white and orange alternately while its firmware is being updated.

Charging Dock

Clean the contacts of the charging dock with a soft cloth.

System Restarting

If the vacuum-mop stops responding or cannot be turned off, press 

and hold down the button 

 for 6 seconds to forcefully turn it off. 

Then press and hold the button 

 for 3 seconds to turn the 

vacuum-mop on.

Restoring Factory Settings

If system restarting does not work, use a pin to press the reset button 

until you hear a voice say "Restoring factory settings". This will reset 

the vacuum-mop to its original factory settings.

Fault

Error 1: Please clean and gently tap the bumper.

Solution

If the vacuum-mop encounters an error during operation, the power indicator will blink orange and you will hear a voice alert. To check for a solution, 

please refer to the table below.

If the collision buffer is stuck, gently tap it to remove foreign objects. If it does 

not work, move the vacuum-mop to a new area and reactivate it.

Error 2: Please place the vacuum-mop on the level 

ground and reactivate it.

Error 3: Please clean the cliff sensor, place the vacuum 

on level ground, and reactivate it.

A wheel is off the ground. Place the vacuum-mop on the level ground and 

reactivate it.

Part of the vacuum is off the ground. Place the vacuum on level ground and 

reactivate it. This error may also occur if the cliff sensor is dirty. To rule out this 

possibility, clean the cliff sensor.

Error 4: Please remove the main brush and clean the 

bristles and bearings.

A foreign object might be caught in the main brush. Remove the brush and 

clean its bristles and bearings.

Error 6: Please check whether any objects are wrapped 

around the main wheels, then move the vacuum-mop 

to a new location and reactivate it.

A foreign object might be caught in one of the main wheels. Clean the wheels, 

then reactivate the vacuum-mop.

Error 7: Please clear any obstacles around the 

vacuum-mop.

The vacuum-mop may be caught or stuck. Clear away any obstructions around it.

Error 8: Please reinstall the dust bin and filter.

Make sure the dust bin and filter are installed correctly. If the error persists, try 

replacing the filter.

Error 5: Please remove and clean the side brush.

A foreign object might be caught in the side brush. Remove the side brush and 

clean it.

Troubleshooting

15

16