Mi Robot Vacuum-Mop SKV4093GL - Инструкция по эксплуатации - Страница 5

Note: Certain types of floor cleaners or disinfectants may 

clog the tank filter. Please exercise caution when selecting 

which product to use.

Note: When the vacuum-mop is charging or not in use, remove the mopping module, pour out all 

remaining water in the tank, and clean the mop pad to prevent mildew or lingering odors.

c. Install the mopping module: Align the mopping module as indicated 

by the arrow, then slide it into the back of the vacuum until it clicks 

into place.

b. Fill the water tank: Open the water tank 

lid, fill the tank with water, then securely 

close the lid.

After the vacuum-mop finishes cleaning and returns to the charging 

dock, press the side clips of the mopping module inward and pull to 

remove the module.

6. Remove the Mopping Module

Press and hold the button       

，

 When the power indicator lights up, 

place the vacuum-mop onto the charging dock to recharge.

Installation

2. Turn on and charge the vacuum-mop

Battery Level Indicator
White:  Battery level is more than 15% 
Orange: Battery level is less than 15% 

> 0.5 m

> 1.5 m

> 0.5 m

Note: Only use the mopping module when someone is at 

home. To prevent the vacuum from entering carpeted areas, 

objects may be used.

Note: The mop pad should be cleaned after every 30 minutes of use to ensure adequate water flow 

and cleaning effectiveness.

a. Install the mop pad: Dampen the mop 

pad and wring out excess water. Slide the 

pad all the way into the slot of the water 

tank until it is securely in place. 

Once the power indicator of the vacuum-mop changes from pulsing 

white to solid white, it is fully charged. Press the button 

, or you can 

use the Mi Home/Xiaomi Home app to start cleaning.

4. Install the mopping module

5. Start Cleaning

This product works with Mi Home/Xiaomi Home app *. Control your 

device, and interact it and other smart home devices with Mi 

Home/Xiaomi Home app. Scan the QR code to download and install 

the app. You will be directed to the connection setup page if the app is 

installed already. Or search "Mi Home/Xiaomi Home" in the app Store 

to download and install it. Open Mi Home / Xiaomi Home app, tap "+" 

on the upper right, and then follow prompts to add your device. 

* The app is referred to as Xiaomi Home app in Europe (except for Russia). The name of the app 

displayed on your device should be taken as the default.
Note: The version of the app might have been updated, please follow the instructions based on the 

current app version.  

3. Connecting with Mi Home/Xiaomi Home App

1. Place the charging dock on the level ground 

against wall and connect to a power outlet

Note: Make sure there is a distance of 0.5 meters or more on either side of the charging dock, and 

more than 1.5 meters in front of it. Connect the power cord to the charging dock and tidy up any 

loose cord to prevent it from getting tangled up by the vacuum-mop, which could accidentally 

move or unplug the charging dock.

Note: If the vacuum-mop is unable to turn on due to low battery, place it directly onto the charging 

dock to recharge.

When there is a connection loss between your phone and the 

vacuum-mop due to the router reconfiguration, wrong password or so, 

please open the cover of the vacuum-mop so that you can see the 

Wi-Fi indicator. Simultaneously press and hold the buttons        and 

until you hear a voice saying "Waiting for the network configuration". 

Once the Wi-Fi indicator is slowly blinking, the Wi-Fi has been 

successfully reset.

Reset Wi-Fi

7

8