Thomas Hygiene T2 - Инструкция по эксплуатации - Страница 21

19

Empty the waste water tank after you have used up all the 

cleaning agent from the fresh water tank to prevent the 

appliance being switched off automatically.

Should you not observe the above-mentioned instructions the 

float will automatically switch off the appliance as soon as the 

waste water tank is full. (You will clearly hear the motor be 

running at a higher speed.)

Switch off appliance, disconnect the mains plug and empty the 

waste water tank.

hard floor cleaning

Drop the hard floor adapter over 

the carpet spraying nozzle and 

lock by means of the slide. 
By using this system you can clean 

and dry your hard floor coverings 

such as tiles, stone floors and PVC 

at one and the same time.

See carpet cleaning for 

procedure.

We recommend 

THOMAS ProFloor cleaning agent

 for hard 

floor cleaning.

Maintenance cleaning of smooth floor coverings such 

as linoleum, PVC, tiles, polished stone floors and lami-

nate floors with the microfibre pad 

– General instructions: 

Proper care of floors is an essential component 

under our terms of guarantee! 

To be observed without fail are the special care 

instructions of the manufacturer of the floor 

coverings. 

The surface protection finish can be damaged or destroyed when 

cleaning and using aggressive universal cleaners. 

Maintenance cleaning is to be carried out by dust suction or by wiping 

over with moist cloth. 

Atomised moisturisation means: The floor must be completely dry 

after 3-5 minutes. This method is only to be used on laminate floors 

when recommended by manufacturer. 
Wash the microfibre pad before using it for the first time to remove 

any possible residue given as a result of the production process. 

We recommend 

THOMAS ProFloor cleaning agent 

for main-

tenance cleaning of smooth floor coverings such as linoleum, PVC, 

tiles, polished stone floors and laminate floors. 

Dismantling/assembling: 

1.

2.

3.

5.

4.

6.

   We  recommend 

THOMAS ProTex original cleaning 

detergent

 for cleaning carpets.

See label on the cleaning agent bottle for application and 

dosage.

Use hand warm water (max. 30°C).

Connect up suction hose and fit telescopic suction tube.

 Fit carpet spray nozzle, spraying hose to the suction tube with 

fast coupling and move upwards and place on the shut-out 

valve and lock by turning. Afterwards fasten the spray hose 

by means of the two tube clips on the suction tube.

Pull out the mains power supply plug and cable from the 

appliance and connect up.

Switch on the appliance and set for maximum suction power. Switch 

on pump. Control lamp comes on.

Press the lever on the shut-off valve (24) until the cleaning agent 

escapes. Draw the nozzle straight over the carpet and press 

it down at the same time. The spraying volume can be set as 

required by means of the setting wheel on the handle. Release 

the valve lever to stop spraying at the end of one run or when 

stopping work. When the sprayed liquid has been sucked up, 

lift the nozzle and begin a new run but overlap slightly. In this 

way you can clean the entire area section by section.

Should there still be traces of liquid remaining on the cleaned 

areas this liquid can be sucked up without having to spray 

again.

    Make sure that the mechanical suction controller (25) is 

completely closed.

In the case of very stubborn dirt you can apply the cleaning 

agent while moving the carpet spraying nozzle forwards. The 

same treatment can also be applied by just putting the pump 

into operation.

Ensure that you do not spread too much liquid over the carpeting 

since this may cause waves or bumps in the carpet. However, these 

will disappear again after being allowed to dry for a longer period 

of time.

Absaugen und

Aufrichten

Arbeitsrichtung
Einsprühen

Sa

ug

roh

r

Dr

uc

kle

itu

ng

Lösen und Auswaschen

Suction tube

Releasing and washing out

 Spraying

Sucking up and 

straightening

Pressur

e line

Working direction

Spray extraction system

• 

Spray the cleaning agent deep into the carpet under pressure

• 

This releases the dirt and washes out deep down into the fibres

• 

Suck up the dirty water at full power and straighten up the 

carpet pile again.

This should be always carried out in a single operation.

2.

1.