Makita DHS900Z - Инструкция по эксплуатации - Страница 23

ENGLISH

3.

  Set the stand-by switch on the vacuum cleaner to 

"AUTO".

► 

Fig.43:

1.

 Stand-by switch

4.

  Push the wireless activation button on the tool 

briefly. The wireless activation lamp will blink in blue.

► 

Fig.44:

1.

 Wireless activation button 

2.

 Wireless 

activation lamp

5.

  Pull the switch trigger of the tool. Check if the 

vacuum cleaner runs while the switch trigger is being 

pulled.
To stop the wireless activation of the vacuum cleaner, 

push the wireless activation button on the tool.

NOTE:

 The wireless activation lamp on the tool will 

stop blinking in blue when there is no operation for 

2 hours. In this case, set the stand-by switch on the 

vacuum cleaner to "AUTO" and push the wireless 

activation button on the tool again.

NOTE:

 The vacuum cleaner starts/stops with a delay. 

There is a time lag when the vacuum cleaner detects 

a switch operation of the tool.

NOTE:

 The transmission distance of the wireless unit 

may vary depending on the location and surrounding 

circumstances.

NOTE:

 When two or more tools are registered to one 

vacuum cleaner, the vacuum cleaner may start run

-

ning even if you don't pull the switch trigger because 

another user is using the wireless activation function.

Description of the wireless activation lamp status

► 

Fig.45:

1.

 Wireless activation lamp

The wireless activation lamp shows the status of the wireless activation function. Refer to the table below for the 

meaning of the lamp status.

Status

Wireless activation lamp

Description

Color

On

Blinking

Duration

Standby

Blue

2 hours

The wireless activation of the vacuum cleaner is available. The 

lamp will automatically turn off when no operation is performed 

for 2 hours.

When 

the tool is 

running.

The wireless activation of the vacuum cleaner is available and the 

tool is running.

Tool 

registration

Green

20 seconds

Ready for the tool registration. Waiting for the registration by the 

vacuum cleaner.

2 seconds

The tool registration has been finished. The wireless activation 

lamp will start blinking in blue.

Cancelling 

tool 

registration

Red

20 seconds

Ready for the cancellation of the tool registration. Waiting for the 

cancellation by the vacuum cleaner.

2 seconds

The cancellation of the tool registration has been finished. The 

wireless activation lamp will start blinking in blue.

Others

Red

3 seconds The power is supplied to the wireless unit and the wireless activa-

tion function is starting up.

Off

-

-

The wireless activation of the vacuum cleaner is stopped.

Cancelling tool registration for the 

vacuum cleaner

Perform the following procedure when cancelling the 

tool registration for the vacuum cleaner.

1.

  Install the batteries to the vacuum cleaner and the 

tool.

2.

  Set the stand-by switch on the vacuum cleaner to 

"AUTO".

► 

Fig.46:

1.

 Stand-by switch

3.

  Press the wireless activation button on the vac-

uum cleaner for 6 seconds. The wireless activation 

lamp blinks in green and then become red. After that, 

press the wireless activation button on the tool in the 

same way.

► 

Fig.47:

1.

 Wireless activation button 

2.

 Wireless 

activation lamp

If the cancellation is performed successfully, the wire

-

less activation lamps will light up in red for 2 seconds 

and start blinking in blue.

NOTE:

 The wireless activation lamps finish blinking in 

red after 20 seconds elapsed. Press the wireless acti-

vation button on the tool while the wireless activation 

lamp on the cleaner is blinking. If the wireless acti-

vation lamp does not blink in red, push the wireless 

activation button briefly and hold it down again.

23