Мойки высокого давления Lavor PRO ARIZONA 1209 LP 8.665.0101 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Cause
t
Insufficient flow.
t
Water inlet filter is clogged.
t
Suction/delivery valves are
clogged or worn out.
t
Pressure regulator valve set
on minimum.
t
The nozzle is worn out.
Repair
t
Check that the delivery rate is
30% higher than the value stat-
ed on the appliance’s technical
data plate.
t
Remove and clean the filter.
t
Contact an authorised service
centre.
t
Increase the pressure by
screwing in the pressure regula-
tor knob.
t
Replace the nozzle.
Fault
'MVDUVBUJOHQSFTTVSF
Cause
t
The nozzle is either clogged or
deformed.
t
Suction/delivery valves are
clogged or worn out.
t
Worn gaskets.
t
Pressure regulator valve gas-
kets worn.
t
The filter is dirty.
Repair
t
Dismantle the lance and clean
the nozzle with
the pin provided.
Contact an authorised serv-
ice centre.
Contact an authorised serv-
ice centre.
Contact an authorised serv-
ice centre.
Remove and clean the filter.
Fault
8BUFSMFBLGSPNBQQMJBODF
Cause
t
Water leaking from the pump.
t
Leaks from hose reel (if
present).
t
Leaks from pressure regulator
valve.
t
Leaks from water unions.
Repair
t
Contact an authorised service
centre.
t
Tighten the unions; if the
problem persists, contact an
authorised service centre.
t
Contact an authorised service
centre.
t
Tighten the unions; if the
problem persists, contact an
authorised service centre.
Fault
Abnormal noise
Cause
t
Suction/delivery valves are
clogged or worn out.
t
Worn bearings.
t
The filter is dirty.
t
Extreme water temperature.
Repair
t
Contact an authorised service
centre.
t
Contact an authorised service
centre.
t
Remove and clean the filter.
t
Bring the temperature under
50°.
Fault
8BUFSJTJOUIFPJM
Cause
t
O-rings (water and oil) are
worn out.
Repair
t
Contact an authorised service
centre.
Fault
The machine does not suck
wax or detergent
Cause
t
Tanks empty.
t
Rod knob on high pressure
position.
t
Disconnected pipe in deter-
gent suction system.
Repair
t
Replace oil with double fre-
quency that is suggested.
t
Fill the tanks.
t
Turn it to the low pressure po-
sition.
t
Return it into position.
>
3&1"*3441"3&1"354
For any problems not mentioned in this manual, or if
EN
21
