Karcher HD 830 BS 1.187-113 - Инструкция по эксплуатации - Страница 13

English

 13

Î

Connect high pressure hose and spray 
pipe to the hand spray gun. 

Î

Install the nozzle on the spray pipe in 
such a way that the marking is on the 
top. 

Î

Tighten covering nut firmly.

Î

Connect the high pressure host to the 
high pressure connection point of the 
machine. 

–

For connection values refer to technical 
specifications

–

Observe regulations of water supplier. 
According to DIN 1988 it is not allowed to 
connect the device directly to the public 
water supply. A brief connection through 
a pipe interruptor (Order Nr. 6.412-578) 
is admissible. The high pressure cleaner 
is to be separated from the water supply 
after use.

Î

Connect the supply hose to the water 
connection point of the machine and at 
the water supply point (for e.g. a tap). 

Î

Open the water supply.

Note

The supply hose is not included.



Danger

Never suck in water from a drinking water 
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil 
or unfiltered water. The sealings within the 
device are not solvent resistant. The spray 
mist of solvents is highly inflammable, explo-
sive and poisonous.

Î

Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the wa-
ter connection point. 

Î

Set dosing value for detergent to "0". 

Î

Remove air from appliance before oper-
ation.

Î

Open the water supply.

Î

Start the engine according to the operat-
ing instructions of the engine manufac-
turer. 

Î

To dearate the appliance, unscrew the 
nozzle and allow the appliance to run un-
til the water exits in a bubble-free state. 

Î

Switch off the appliance and fit the noz-
zle again. 



Danger

–

Place the appliance on firm surface. 

–

The high pressure cleaner  must not be 
used by children. (Risk of accident on ac-
count of improper use of the appliance).

–

The high pressure spray generates high 
levels of noise when the appliance is in 
use.  Risk of hearing impairment.  Al-
ways use proper ear-protection aids 
while working with the appliance.

–

The water jet coming out of the high 
pressure nozzle causes the gun to recoil. 
Further, an angular spray pipe can cause 
additional torque.  Hence hold the spray 
pipe and gun firmly. 

–

Wash animals only with a flat low pres-
sure jet (see "Select spray type").

–

Vehicle tyres/ tyre valves may be 
cleaned only with a minimum spray dis-
tance of 30 cm. Otherwise, the high pres-
sure spray can cause damage to the 
vehicle tyre/ tyre valve.  The discolouring 
of the tyre is the fhe first sign of damage.   
Damaged vehicle tyres are a source of 
danger.

–

Do not spray materials contains asbestos 
or other health-hazardous substances. 

–

The operator must wear proper safety 
gear to be protected against the water 
sprays. 

–

Pay attention to ensure that all screws of all 
connecting hoses are tightened properly. 

–

The lever of the hand spray gun must not 
be locked during the operation.

Install hand spray gun

Water connection

suck in water from vessel

Dearating the appliance

Operation