VITEK VT-6404 - Инструкция по эксплуатации - Страница 5

                                                                                           English

5

DESCRIPTION
BASE UNIT

1.  Display
 

Displaying of current time (a), date 
(b), sunrise (c) and sunset time 
(d), temperature and humidity 
values from the remote sensor (e) 
and inside the room (f), pressure 
(g), lunar phases (h) and symbolic 
weather forecast (i).

.  The Max/Min/+ button. 

Displaying of maximal/minimal 
temperature, setting of current 
time, alarm time, date, as well as 
temperature and humidity value 
limits.

.  The Mode button 

Switching between the current 
time modes Clock 1/Clock , 
Alarm 1/Alarm  modes, entering 
the set up mode.

.  The Alarm/Channel/°C/°F button 

Switching on/off of Alarm 1/
Alarm  modes, signal switching 
from the remote sensors (from 
1 till ).

5.  The Select/- button 

Setting the current time, alarm, 
date as well as temperature and 
humidity value limits.

6.  The Snooze/Light button 

Activation of the snooze function 
and switching of the backlight of 
the display.  

7.  Battery compartment 

(for three 

“АА” batteries)

8. 

Wall-mount holder

9.  Table stand

REMOTE TEMPERATURE AND HU-
MIDITY SENSOR

10.  LCD-display reflect temperature 

and humidity values  

11.  The SET button 

Entering of HOUSE CODE, 
adjusting of channels.

1.  External wire sensor jack
1.  The 

°C/°F

 button 

Switching between the Celsius 
and Fahrenheit scales, change of 
channels and house code.

1. 

Battery compartment 

(for three 

“АА” batteries)

15.  Wall-mount holder/table stand
16.  External wire sensor

BEFORE YOU BEGIN

For best operation insert the batteries 
firstly in the remote sensor and then in 
the base unit. 

Placing batteries in the remote 
sensor

1.  Unscrew the screws on the battery 

compartment lid.

Insert  batteries 

(“АА”, 1.5 V), following the polarity.

.  The HOUSE CODE will start 

flashing on the LCD-display for 
8 seconds. HOUSE CODE – is a 
frequency signal, sent from the 
remote sensor to the base unit. 
All remote sensors in your system 
should have the same HOUSE 
CODE.

6404IM.indd   5

20.08.2008   15:57:03