Hyundai Electronics H-CMD2009 - Инструкция по эксплуатации - Страница 5

5

Installation/Connection

Installation

General notes

•   Choose the mounting location where the 

unit will not interfere with the normal driving 
function of the driver.

•   Before finally installing the unit, connect 

the wiring and make sure that the unit works 
properly.

•   Consult with your nearest dealer if 

installation requires the drilling of holes or other 
modifications of the vehicle.

•   Install the unit where it does not get in the 

driver’s way and cannot injure the passenger if 
there is a sudden stop, like an emergency stop.

•   If installation angle exceeds 35° from 

horizontal, the unit may not perform properly.

•   Avoid installing the unit where it would 

be subject to high temperature, such as from 
direct sunlight, or from hot air, from the heater, 
or where it would be subject to dust, dirt or 
excessive vibration.

Mounting

•   Remove the mounting sleeve (1) from the 

unit.

•   Slide the mounting sleeve into the 2-DIN 

installation slot provided for the car radio.

•   Attach the mounting sleeve by bending the 

installation brackets towards the outside with 
a screwdriver. The sleeve is properly installed 
when it can no longer be pulled out, yet also 
keeps from sliding into the installation slot.

•   Connect the cable set and the antenna to 

the vehicle’s electronics corresponding to the 
connection table (see farther).

•   Attach the mounting racks to the sides of 

the unit, and fix them with the screws as in (2).

•   Insert the unit into the mounting sleeve 

until the stop (3). The unit then audibly snaps 
into the sleeve.

•   Fasten the four screws (4) to fix the unit to 

the mounting sleeve.

•   Place the trim ring (5) over the unit and 

the installation is completed. (Some vehicles 
may not need a trim ring).

•   The device is distinguished by a high 

4