Mitsubishi Electric MSZ-GF60VE - Инструкция по эксплуатации - Страница 7

En-6

I-

SAVE OPERATION  

1

Press 

 during COOL, ECONO COOL, or HEAT 

mode to select i-save mode.

2

Set the temperature, fan speed, and airfl ow direction.

•  The  same  setting  is  selected  from  the  next  time  by  simply  pressing 

 .

•  Two  settings  can  be  saved.  (One  for  COOL/ECONO  COOL,  one  for 

HEAT)

•  Select  the  appropriate  temperature,  fan  speed,  and  airflow  direction 

according to your room.

•  Normally,  the  minimum  temperature  setting  in  HEAT  mode  is  16°C. 

However, during i-save operation only, the minimum temperature set-

ting is 10°C.

Press 

 again to cancel i-save operation. 

•  i-save operation also is canceled when the MODE or POWERFUL but-

ton is pressed.

i-save operation

•  A simplified set back function enables to recall the preferred (preset) setting 

with a single push of the 

 button. Press the button again and you can go 

back to the previous setting in an instance.

•  i-save operation cannot be set on the weekly timer.

Example of use:

1.  Low energy mode

Set the temperature 2°C to 3°C warmer in COOL and cooler in HEAT mode. 

This setting is suitable for unoccupied room, and while you are sleeping.

2.  Saving frequently used settings

Save your preferred setting for COOL/ECONO COOL and HEAT. This ena-

bles you to select your preferred setting with a single push of the button.

Note:

When  using  the  multi  system  MXZ-8A140,  the  temperature  cannot  be  set  to 

10°C.  Even  if  the  temperature  is  set  to  10°C,  the  air  conditioner  will  operate 

at 16°C.

E

CONO COOL OPERATION  

Press 

 during COOL mode 

 page 4 

 to start 

ECONO COOL operation.

The unit performs swing operation vertically in various cycles according to the 

temperature of airflow.

Press 

 again to cancel ECONO COOL operation. 

•  ECONO  COOL  operation  is  canceled  when  the  VANE,  LONG,  or 

POWERFUL button is pressed.

What is “ECONO COOL”?

Swing airfl ow (change of airfl ow) makes you feel cooler than stationary airfl ow.

The set temperature and the airfl ow direction are automatically changed by the 

microprocessor.

It is possible to perform cooling operation with keeping comfort.

As a result energy can be saved.

1

Press 

 or 

 during operation to set the timer. 

 (ON timer) :    The unit turns ON at the set time.

 (OFF timer) :  The unit turns OFF at the set time.

* 

 or 

 blinks.

*  Make sure that the current time and day are set correctly. 

Page 3

2

Press 

 (Increase) and 

 (Decrease) to set the 

time of timer. 

Each press increases or decreases the set time by 10 minutes.

•  Set the timer while 

 or

 is blinking.

3

Press 

 or 

 again to cancel timer.

Note:

•  ON and OFF timers can be set together.   mark indicates the order of timer 

operations.

•  If power failure occurs while ON/OFF timer is set, see 

 page 4 

 “Auto restart 

function”.

T

IMER OPERATION (ON/OFF TIMER)

JG79A927H01_en.indd   6

7/2/2014   11:44:08 AM