Elenberg PRT-9050 - Инструкция по эксплуатации - Страница 36

Troubleshooting 

36

The following cases may not always be a malfunction, please check suggestions below before ask+
ing for service.

Trouble

Analysis

Does not run

If the protector trip or fuse is blown. 
Please wait for 3 minutes and start again, pro+
tector device may be preventing unit to work.
If batteries in the remote controller exhausted. 
If the plug is not properly plugged in.

Runs for a short while only

If the set temperature is close to room temper+
ature, you can lower the set temperature.
Air outlet blocked by obstacle. 
Take the obstacle away.

Runs but not cooling

If the door or window is open.
If there is another appliance heat working.
like heater or lamp, etc. 
The air filter is dirty, please clean it.
Air outlet or intake blocked.
Set temperature is too high.

Water leak during moving

Drain the condensate before moving.

Does not run and water
full indicator lights

Pull out the rubber plug to drain water.
If it is often in this state, please contact quali+
fied service technicial.