DOMETIC FreshJet 1700 9105306658 - Инструкция по эксплуатации - Страница 10

EN

Installation

FreshJet

10

•

Before installation, find out (by consulting the manufacturer of the vehicle) 
whether the construction is designed for the static weight and the loads of the air 
conditioner when the vehicle is in motion. The manufacturer of the roof air 
conditioner assumes no liability whatsoever.

•

The vehicle manufacturer may have already provided points where the opening 
for the installation of the roof air conditioner can be made without any risk of 
weakening the construction or cutting power cables.

•

Select a flat and sufficiently level area at the centre of the vehicle roof between 
two longitudinal sections for installation.

•

The roof inclination of the installation surface may not exceed 10°.

•

The roof air conditioner must be installed above 2 meters.

•

Make sure no combustible objects are stored or installed near the air outlet. A 
distance of at least 50 cm should be kept.

•

Make sure that there are no objects within the vehicle which could obstruct the 
attachment of the air outlet unit or the cooled air from flowing through the 
swivelling air distribution nozzles.

•

For safety reasons, note the location of existing wiring harnesses, wires and other 
components within the installation area, in particular those which are not visible, 
when installing the roof air conditioner (when drilling or screwing etc.). 

•

The device shall be installed, operated and stored in a room with a floor larger 
than 4 m

2

.

Note on electrical system

•

Only a qualified electrician should connect the roof air conditioner to the 
electrical power.

•

Check that the voltage specification on the type plate is the same as that of the 
power supply.

•

If the lighting should also be switched on without a 230 V voltage supply, make 
sure that there is a 12 V

g

 power supply line from the battery to the roof air 

conditioner.

•

Do not lay the 230 V mains cable and the 12/24 V

g

 cable together in the same 

cable duct.

•

Do not lay cables which are loose or bent next to electrically conductive material 
(metal).

•

Install an all-pole switch with a contact opening width of at least 3 mm on the 
installation side.

•

If the appliance is powered by the mains, ensure that the 230 V voltage supply 
has a residual current circuit breaker.

DometicFJ1700-FJ2000-FJ2200-FJ3200_INM_4445101815_EMEA16_202x-xx-xx.book  Seite 10  Mittwoch, 13. Januar 2021  5:16 17