Кофеварка Siemens TK 52001 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
15
15
● Wipe out or vacuum the inside of the
appliance (tray holders).
● Open the doors to the brewing unit
21
and remove any coffee residues. Close
the doors.
Note: If the appliance is cold when
switched on with the stand-by button
a
, or if
it is set to stand-by after brewing coffee, it is
automatically rinsed, i.e. the system cleans
itself.
Nozzle 8 for hot water/steam
● Unscrew the nozzle
8 from the steam
pipe.
● Dismantle all parts (
Fig. D).
● Clean with a caustic cleaning solution and
a soft brush. Clean the tip of the nozzle
8/c with a blunt needle.
● Thoroughly rinse and dry all parts.
Service programme:
Combined cleaning and
descaling process
If the
S
LED lights up while the appliance
is on, the service programme must be
run immediately to clean and descale the
appliance. If the service programme is not
run as instructed, the appliance may be
damaged.
Specially developed descaling (Order
No. 310451) and cleaning agents (Order
No. 310575) can be obtained from our
customer service department.
Warning
Each time you run the ser vice programme,
follow the instructions for using the cleaning
and descaling agents.
Never interrupt the ser vice programme.
Do not drink the liquids.
Never use vinegar or vinegar-based
products.
Never put descaling tablets or other
descaling materials into the duct for
cleaning tablets.
i
The
S
LED lashes while the service
programme is running (approx. 40
minutes).
Important: If there is a filter in the water
tank, it must be removed before the service
programme is run.
Starting the service programme
● Switch the appliance to standby mode
using the stand-by button
a
.
● Empty and replace the trays
17 and 18.
● Hold down the mild coffee button
5
for at
least 5 seconds.
The
S
LED starts to lash
and the
appliance rinses the coffee dispenser
through twice.
● Empty and reinsert the grounds tray
17.
The steam button LED
h
lashes and the
H
LED lights up.
● Place
one cleaning tablet in the duct 13.
● Fill the water tank with lukewarm water,
add descaling agent and dissolve
completely (total liquid: 0.5 litres).
or
● Pour prepared descaling mixture into the
water tank (total liquid: 0.5 litres).
● Press the steam button
h
. The descaling
process begins. Duration approx. 10
minutes. The descaling solution lows into
the water tray 18.
The
J
LED lashes.
● Place a suitable container (approx. 0.5
litres) under the nozzle 8.
● Set the dial
6 to
g
/
h
. The descaling
process begins. Duration approx. 5
minutes. The descaling solution lows into
the container.
The
I
LED lights up.
● Empty and reinsert the grounds tray
17.
The steam LED
h
lashes.
● Empty and clean the water tank
11,
ill
with fresh water up to the “max“ mark and
reinsert.
en
en
