Кофеварка Siemens TK 52001 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
11
11
Switching on the appliance
● Pull enough of the power cord out of the
storage compartment and plug it into the
electrical socket.
● Remove and rinse the water tank
11
and ill it with fresh cold water. Do not ill
above the “max“ mark.
● Replace the water tank
11 and push it
irmly down into place.
● Fill the bean container with coffee beans.
● Set the power switch
1 to I. The stand-by
LED
a
lights red.
● Make sure that the hot water/steam dial
6
is at O.
● Press the standby button
a
. The
J
LED lashes.
Filling the system
When switched on for the irst time, the
water pipes in the appliance must be illed.
● Place a cup under the nozzle
8.
● Turn the dial
6 to
g
/
h
. Water runs into
the cup.
As soon as
J
lights up, turn the dial 6
back to O.
● The standby button
a
will now lash. The
appliance rinses and heats up.
The appliance is ready for use when the
stand-by LED
a
lights green.
i
The appliance’s factory settings are
programmed for optimal performance.
Controls
1 Power switch
The power switch 1 on the rear of the
appliance switches the power supply on
and off.
When the power is switched on, the
standby LED
a
lights red.
The appliance is now in stand-by mode.
Warning
Do not press the power switch while the
appliance is operating. The appliance
should only be switched off when it is in
stand-by mode.
2 Stand-by button
a
The stand-by button
a
switches the
appliance from stand-by mode to on.
When the stand-by button
a
is pressed, the
appliance heats up. The stand-by button
a
lashes while the appliance heats up and is
rinsed. When the stand-by button
a
lights
green, the appliance is ready for operation.
The appliance will not be rinsed if:
– it is still warm when switched on, or
– coffee was not dispensed before it was
switched to stand-by mode.
Note: After 3 hours, the appliance
automatically switches to stand-by mode.
3 Coffee dispensing button
5
(mild coffee)
This button is used to dispense mild coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
4 Coffee dispensing button
K
(strong coffee)
This button is used to dispense strong
coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
5 Steam generation button
h
The steam button
h
generates steam for
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to
g
or
h
. To dispense
steam, the steam generation button
h
must be pressed irst (see “Steam for
frothing milk“).
7 LED display
The various LEDs indicate the following:
H
on
The water tank is empty and
needs to be illed.
I
on
Trays full:
Empty and replace them.
I
lashing Trays missing:
Reinsert them.
en
en
