Кофемашина Bosch TCA 5309 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
17
TCA53 03/2012
en
Steam for foaming milk
The appliance must be ready for use. You
can foam the milk irst and add the coffee
on top, or foam the milk separately and
pour it into the coffee.
¡
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
● Push the sleeve on the nozzle
8
all the
way down.
● Fill the cup approximately 1/3 full of milk.
● Press the steam button
h
. The LED will
start to lash.
i
The appliance will heat up for approx.
20 seconds.
● Immerse the nozzle
8
deep into the milk,
but do not let it touch the bottom of the
cup.
● As soon as the LED
J
lights up, turn the
rotary button
6
to
g
/
h
.
¡
Risk of scalding
When the dial
6
is set to
g
/
h
, the nozzle
8
may sputter. Escaping steam is very hot
and may cause liquids to sputter. Do not
touch the nozzle
8
or point it at anyone.
● Rotate the cup slowly until the milk is fully
foamed.
● End the process by turning the dial
6
back to “
O
”.
i
To foam more milk, press the steam
button
h
again and repeat the whole
process.
Note:
When the nozzle
8
has cooled down,
clean immediately. Dried residue is dificult
to remove.
Tip:
If possible, use cold lowfat (1,5 % fat)
milk.
Steam for heating drinks
¡
Risk of burns
The nozzle gets very hot. Do not touch the
metal parts.
The appliance must be ready for use.
● Push the sleeve on the nozzle
8
all the
way
up
.
● Press the steam button
h
. The LED will
start to lash.
i
The appliance will now heat up for
approx. 20 seconds.
● Immerse the nozzle
8
deep into the liquid
you want to heat.
● As soon as the LED
J
lights up, turn the
rotary button
6
to
g
/
h
.
¡
Risk of scalding
When the dial
6
is set to
g
/
h
, the nozzle
8
may sputter a little. Escaping steam is
very hot and may cause liquid to sputter. Do
not touch the nozzle
8
or point it at anyone.
● End the process by turning the dial
6
back to “
O
”.
i
To generate more steam, press the steam
button
h
again and repeat the whole
process.
Note:
When the nozzle
8
has cooled down,
clean immediately. Dried residue is dificult
to remove.
