Hiberg RFC-400DX NFGB inverter - Инструкция по эксплуатации - Страница 42

42

ATTENTION! 

The refrigerator must be 

disconnected from the power supply 

before and during cleaning, otherwise 

there is a risk of electric shock!

For hygienic reasons, it is recom-

mended to clean the refrigerator/freezer 

at least once every 2 months.

External cleaning

To maintain a good appearance of the 

refrigerator, it must be cleaned regularly.

1. Wipe the digital display and control 

panel with a clean soft cloth.

2. Apply water on a cloth (rag), not on 

the refrigerator. This will ensure an 

even distribution of moisture on the 

surface.

3. Apply a mild detergent to the doors, 

handles and body of the refrigerator 

and wipe dry with a soft cloth.

ATTENTION!

Do not use sharp objects for cleaning, 

as they may scratch the surface of 

the refrigerator.

Do not use solvents, car detergents, 

bleach, essential oils, abrasive clean

-

ers or organic solvents such as ben-

zene to clean the refrigerator. They 

can damage the surface and/or cause 

a fire.

Internal cleaning

You should clean the refrigerator 

regularly. Wipe the refrigerator from the 

inside with a weak sodium bicarbonate 

solution and rinse with warm water us-

ing a wrung sponge or rag. Wipe all sur-

faces dry before placing shelves, draw-

ers and baskets. Thoroughly wipe all the 

walls and removable parts.

Despite the fact that this refrigerator 

is equipped with an automatic defrosting 

function, a small layer of frost can nev-

ertheless form on the walls of the freezer 

compartment after frequent or pro-

longed opening of the door. If the frost 

layer is too large, follow these steps:

1. Remove all products, shelves, ac-

cessories, baskets, disconnect the 

refrigerator from the power supply 

and leave the doors open. Ventilate 

the room to speed up the defrosting 

process.

2. Upon completion of defrosting, clean 

the freezer compartment  according 

to the above recommendations.

ATTENTION! 

Only after the inner surface of the 

refrigerator becomes completely 

dry, it can be connected to the power 

supply.

Cleaning of door seals

Make sure that the door seals are al-

ways clean. Sticky food and beverages 

touching the seal may cause the seal to 

stick to the refrigerator door frame and 

tear the seal when the door is opened. 

Wipe the seal with a mild detergent and 

warm water, then wipe dry.

ATTENTION! 

Only after the refrigerator door 

seals are completely dry it can be 
connected to the power supply.

Replacement of LED lighting

ATTENTION! 

The user shall not replace the LED 

bulb by himself! If it is damaged, 

please, contact the specialists 

for help using the toll-free hotline 

number.

CLEANING AND CARE