AKSA AAP2200i - Инструкция по эксплуатации - Страница 46

Генераторы AKSA AAP2200i - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.

Если остались вопросы, задайте их в комментариях после инструкции.

"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Страница:
/ 64
Загружаем инструкцию
background image

13

OPERATION

Grounding the Generator

To avoid electrocution, this generator must be properly grounded prior to use.  For instructions see Control Panel Functions 

pg. 10.

Standard Atmospheric Conditions

Ambient Temperature: 77ºF (25ºC)

Barometric Pressure: 100kPa

Relative Humidity: 30%

Generator output will vary due to changes in temperature, altitude, and humidity.  If the temperature, humidity, or altitude are 

higher than standard atmospheric conditions, the generator’s output will be reduced.  The load attached to the generator 

must therefore be reduced.

How to Start Engine

Place generator on a level surface.  All electrical loads 

MUST

 be disconnected from generator.

Turn the ECO switch to “OFF”

Turn the Air Vent to the “ON” position.

Turn the 3 in 1 Start Switch to “CHOKE”

Pull recoil handle (starter cord) slowly until resistance is felt, then pull rapidly.

Let engine run for several seconds and then gradually, as engine warms up, turn the 3 in 1 Start Switch to the “ON”

position.

Note:

 

To start the generator with the ECO switch in the “ON” position

Disconnect all electrical loads from generator.

If ambient temperature is below 32ºF (0ºC) allow 3 minutes for the engine to warm up.

The ECO is in “ON” position, the unit returns to normal operation after the above warm up time.

ECO switch must be turned to the “OFF” position when using electronic devices that require a large starting current,

such as a compressor.

To avoid recoil, pull starter cord slowly until resistance is felt, then pull rapidly.

WARNING!

Pull cord recoils rapidly and pulls arm towards engine faster than you can let go which

could result in injury.

O N

O F F

节 能

模 式

关 闭

开 启

Характеристики

Оцените статью
tehnopanorama.ru
Остались вопросы?

Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)

Задать вопрос

Часто задаваемые вопросы
Как посмотреть инструкцию к AKSA AAP2200i?
Необходимо подождать полной загрузки инструкции в сером окне на данной странице
Руководство на русском языке?
Все наши руководства представлены на русском языке или схематично, поэтому вы без труда сможете разобраться с вашей моделью
Как скопировать текст из PDF?
Чтобы скопировать текст со страницы инструкции воспользуйтесь вкладкой "HTML"