Газонокосилки Viking МВ 248.3 T 63500113418 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
0478 111 9822 C - EN
38
●
Detach the grass catcher box. (
●
Hold the grass catcher box by the
handles (1) and (2) and empty it of
clippings.
●
Ensure that flap (3) is properly closed.
Attach the grass catcher box. (
11
.
1
General
Annual service by the specialist dealer:
The lawn mower should be inspected once
annually by a specialist dealer. VIKING
recommends VIKING specialist dealers.
11
.2 Cleaning the machine
Maintenance interval:
After each use
Cleaning position:
●
Select cutting level 1. (
●
Release the upper handlebar (1) by
unscrewing the two rotary handles (2).
●
Open the discharge flap and hold it
open.
●
Place the machine in the cleaning
position until it stands on its own.
11
.3 Engine
Maintenance interval:
See engine instruction manual.
General information:
Observe the operating and maintenance
instructions contained in the attached
engine instruction manual.
To achieve a long service life, it is always
particularly important to maintain a
sufficient level of oil and to change the oil
and air filter regularly.
The recommended oil change intervals as
well as information on engine oil and oil
capacities can also be found in the engine
instruction manual.
The cooling ribs must always be kept clean
to ensure that the engine is adequately
cooled.
11
.4 Checking the mowing blade
wear limit
Maintenance interval:
Before each use.
Check procedure:
The mowing blade (1) must be cleaned
thoroughly before each check procedure.
●
Place the machine in the cleaning
position. (
Mowing blade thickness:
The blade thickness (A) must be at least
2 mm
at any point. The most important
points are marked in the illustration.
(Check using slide calliper).
Wear limit of the cutting edges:
The cutting edges must not be ground
back by more than
5 mm
(distance (B))
during sharpening. When checking, place
a ruler (2) against the front blade edge (3)
and check for wear.
11
. Maintenance
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
Risk of injury!
Stop the engine and remove the
spark plug socket.
Empty the fuel tank (run empty)
before placing the machine in the
cleaning position.
1
3
Risk of injury!
Observe the safety instructions in
the "For your safety" section. (
1
4
Risk of injury!
A worn mowing blade may break
off and cause serious injuries. The
instructions for blade maintenance
must therefore always be
observed.
Mowing blades are subject to
differing degrees of wear
depending on the location and
duration of use. If you use the
machine on sandy ground or use it
frequently under dry conditions, the
mowing blade will be subjected to
greater loads and will wear more
quickly than the average.
