Газонокосилки Viking МВ 248.3 T 63500113418 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
0478 111 9822 C - EN
36
7.6 Removing and attaching the
grass catcher box
Attaching:
●
Open the discharge flap (1) and hold it
open.
●
Attach grass catcher box (2) to
mountings (4) on rear of machine by
means of locating lugs (3).
Ensure that flap (5) is properly closed.
●
Release the discharge flap (1).
Detaching:
●
Open the discharge flap (1) and hold it
open.
●
Lift grass catcher box (2) and remove
rearwards.
●
Slowly close the discharge flap (1).
7.7 Central cutting height
adjustment
Seven
different cutting heights between
25 mm
and
75 mm
can be set.
Cutting level 1:
Lowest cutting height
Cutting level 7:
Highest cutting height
●
Press the cutting height adjustment
lever (1) to the rear wheel (2) with one
hand and hold in position.
●
Set the cutting height adjustment
lever (1) to the required position.
●
Slowly release the cutting height
adjustment lever (1) again and allow it
to engage.
7.8 Fuel and engine oil
Engine oil:
Please consult the engine
instruction manual for the type of
engine oil to be used and the oil capacity.
Check the oil filling level at regular
intervals (see engine instruction manual).
Avoid exceeding or falling below the
correct oil level.
Fuel:
Recommendation:
Fresh good quality fuel.
Please consult the engine
instruction manual for details on the fuel
quality (octane rating).
– Unleaded petrol
A funnel should be used when filling the
tank with fuel (not included in standard
equipment).
The machine is equipped with several
safety devices for safe operation and for
the prevention of improper use.
8.
1
Safety devices
The lawn mower is equipped with safety
devices, which prevent inadvertent contact
with the mowing blade and with ejected
clippings.
These include the housing, discharge flap,
grass catcher box and correctly-installed
handlebar.
8.2 Motorstop lever
The lawn mower is equipped with a
motorstop device.
The engine stops when the motorstop
lever is released during running operation.
The engine and blade come to a standstill
within 3 seconds.
Risk of injury!
The engine must be stopped
before attaching or removing the
grass catcher box.
Risk of injury!
Stop the engine before adjusting
the cutting height.
6
7
Risk of injury!
Note the warnings in the section
"For your safety". (
Avoid damage to the machine.
Top up the engine oil before starting
for the first time (see engine
instruction manual). VIKING
recommends using a suitable filling
aid when topping up the engine oil
(e.g. funnel). The filling aid is not
included in the standard equipment.
8
8. Safety devices
Risk of injury
If a safety device is found to be
defective, the machine must not be
operated. Consult a specialist
dealer; VIKING recommends
VIKING specialist dealers.
Risk of injury!
If the run-on time of the blade
exceeds this delay, stop using the
machine and take it to your
specialist dealer.
