Makita PLM5120N2 - Инструкция по эксплуатации - Страница 12

12

13-3 BLADE MOUNTING TORQUE

Center Bolt 40Nm-50Nm, to insure safe operation of your 
unit. ALL nuts and bolts must be checked periodically for 
correct tightness.
After prolonged use, especially in sandy soil conditions, 
the blade will become worn and lose some of the original 
shape. Cutting efficiently will be reduced and the blade 
should be replaced. Replace with an approved factory 
replacement blade only. Possible damage resulting from 
blade unbalance condition is not the responsibility of the 
manufacturer.
When you change the blade, you must use the original 
type marked on the blade (MAKITA 263001826) (for order 
the blade, pls. contact your local dealer or call our 
company).

WARNING: 

Do not touch rotating blade.

13-4 ENGINE

Refer to the separate engine manual for engine 
maintenance instructions.
Maintain engine oil as instructed in the separate engine 
manual packed with your unit. Read and follow 
instructions carefully.
Service air cleaner as per separate engine manual under 
normal conditions.
Clean every few hours under extremely dusty conditions. 
Poor engine performance and flooding usually indicates 
that the air cleaner should be serviced.
To service the air cleaner, refer to the separate engine 
manual packed with your unit.
The spark plug should be cleaned and the gap reset once 
a season. Spark plug replacement is recommended at the 
start of each mowing season; check engine manual for 
correct plug type and gap specifications.
Clean the engine regularly with a cloth or brush. Keep the 
cooling system (blower housing area) clean to permit 
proper air circulation which is essential to engine 
performance and life. Be certain to remove all grass, dirt 
and combustible debris from muffler area.

14. STORAGE INSTRUCTIONS 

(OFF SEASON)

The following steps should be taken to prepare lawn 
mower for storage.
1. Empty the tank after the last mowing of the season.

a) Empty the petrol tank with a suction pump.

CAUTION:

 Do not drain the petrol in closed 

rooms, in close proximity of open fire, etc. Do not 
smoke! Petrol fumes can cause explosion or fire.
b) Start the engine and let it run until it has used up 

all remaining petrol and stalls.

c) Remove the spark plug. Use an oilcan to fill 

approx. 20 ml oil into the combustion chamber. 
Operate the starter to evenly distribute the oil in 
the combustion chamber. Replace the spark plug.

2. Clean and grease the lawn mower carefully as 

described above under “Lubrication”.

3. Slightly grease the cutter to avoid corrosion.

4. Store the lawn mower in a dry, clean and frost-

protected place, out of reach of unauthorized persons.

CAUTION:

 The engine must have completely 

cooled down before storing the lawn mower.

NOTE:

- When storing any type of power equipment in an 

unventilated or material storage shed, care should be 
taken to rust-proof the equipment. Using a light oil or 
silicone, coat the equipment, especially cables and all 
moving parts.

- Be careful not to bend or kink cables.
- If the starter rope becomes disconnected from rope 

guide on handle, disconnect and ground the spark plug 
wire, Depress the blade control handle and pull the 
starter rope out from engine slowly. Slip the starter 
rope into the rope guide bolt on handle.

Transport

Turn the engine off. Ensure not to bend or damage the 
cutter when pushing the lawn mower over obstacles.