Husqvarna LC 356VP - Инструкция по эксплуатации - Страница 12

Maintenance schedule

CAUTION: Make sure that the air filter is up

and not against the ground when you tilt the

product. Risk of engine damage.

The maintenance intervals are calculated from daily use

of the product. The intervals change if the product is not

used daily.
For maintenance identified with * refer to instructions in 

Safety devices on the product on page 8.

Maintenance

Daily

Weekly

Monthly

Do a general inspection

X

Examine the oil level

X

Clean the product

X

Examine the cutting equipment

X

Examine the cutting cover *

X

Examine the engine brake handle * 

X

Examine the blade brake control * 

X

Examine the muffler *

X

Examine the spark plug

X

Replace the oil (the first time after 5 h of use, then after each 50 h of

use)

X

Clean or replace the air filter

X

Examine the fuel system

X

To do a general inspection

• Make sure that all nuts and screws on the product

are tightened correctly.

To clean the product externally

• Use a brush to remove leaves, grass and dirt.
• Make sure that the air intake on the top of the engine

is not blocked.

• Do not use a high pressure washer to clean the

product.

• If you use water to clean the product, do not flush

water directly on the engine.

To clean the inner surface of the cutting

cover

1. Empty the fuel tank.
2. Put the product on its side with the muffler down.

CAUTION: If the product is put with the

air filter down, the engine can become

damaged.

3. Hose down the inner surface of the cutting cover

with water.

To examine the cutting equipment

WARNING: To prevent accidental start

remove the ignition cable from the spark

plug.

WARNING: Use protective gloves when you

do maintenance on the cutting equipment.

The blade is very sharp and cuts can easily

occur.

1. Examine the cutting equipment for damage or

cracks. Always replace a damaged cutting

equipment.

2. Look at the blade to see if it is damaged or blunt.

Note: It is necessary to balance the blade after it is

sharpened. Let a service center sharpen, replace and

balance the blade. If you hit an obstacle that causes the

product to stop, replace the damaged blade. Let the

service center estimate if the blade can be sharpened or

must be replaced.

To replace the blade

1. Lock the blade with a block of wood. (Fig. 28)
2. Remove the blade bolt.
3. Remove the blade.

12

1227 - 003 - 17.09.2019