Husqvarna LC 356VP - Инструкция по эксплуатации - Страница 11

• Before you pull the product rearward, disengage the

drive and push the product forward approximately 10

cm.

• Release the drive bail to disengage the drive, for

example when you go near an obstacle.

To stop the product

• To stop the drive only, release the drive bail.
• To stop the engine, release the engine brake handle.

To use the product with the grass

catcher (LC 153P, LC 153S, LC

356VP)

WARNING: Do not operate the product

without a grass catcher installed or without

the rear cover closed. Objects can eject and

cause injury to the operator.

1. Lift the rear cover and remove the mulch plug if it is

installed. (Fig. 22)

2. Assemble the grass catcher, refer to 

To assemble

the grass catcher (LC 153P, LB 256S, LC 356VP) on

page 10.

3. Put the grass catcher on the bracket.
4. Release the rear cover and put it on top of the grass

bag frame. (Fig. 23)

To change the product to mulch mode

(LC 153P, LC 153S, LC 356VP)

Make sure the engine is off before you change the

product to mulch mode.
1. Lift the rear cover and remove the grass catcher, if it

is installed.

2. Put the mulch plug into the discharge channel. (Fig.

24)

3. Close the rear cover and make sure that it is tightly

closed against the mulch plug.

4. Replace the blade with the mulch blade that is

supplied in the mulch kit. Refer to 

To replace the

blade on page 12.

To change the product to side

discharge mode

1. Lift the rear cover and remove the grass bag, if it is

installed.

2. Close the rear cover and make sure that it is tightly

closed against the product.

3. Lift the discharge lock. (Fig. 25)
4. Open the side discharge guard and install the side

discharge deflector onto the support pins. (Fig. 26)

5. Let the side discharge guard close against the side

discharge deflector. Make sure that the side

discharge deflector is tightly in position before you

operate the product.

To empty the grass catcher

CAUTION: Do not drag the bag when you

empty the grass catcher to prevent wear.

1. Lift the grass catcher with the frame handle. (Fig. 27)
2. Remove grass clippings from the grass catcher from

below the handle.

3. Empty grass clippings from the bag with the frame

handle and the bag handle.

To get a good result

• Always use a sharp blade. A blunt blade gives an

irregular result and the cut surface of the grass

becomes yellow. A sharp blade also uses less

energy than a blunt blade.

• Do not cut more than ⅓ of the length of the grass.

Use the highest cutting height when you start to cut

the grass. Examine the result and lower the cutting

height to an applicable level. If the grass is very long,

operate slowly and cut 2 times if it is necessary.

• Cut in different directions each time to prevent

stripes in the lawn.

• Lift the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,

remove them.

• Close the rear cover before you operate the product.

When you operate the product, the cut grass

discharges below the rear cover.

Maintenance

Introduction

WARNING: Before you do maintenance, you

must read and understand the safety

chapter.

For all servicing and repair work on the product, special

training is necessary. We guarantee the availability of

professional repairs and servicing. If your dealer is not a

service agent, speak to them for information about the

nearest service agent.

1227 - 003 - 17.09.2019

11