DEFORT DLM-1010N 98299311 - Инструкция по эксплуатации - Страница 10

10

GB

Lubrication

The appliance does not need any extra lubrication.

STORAGE AND TRANSPORTATION

Keep the lawnmower in well-ventilated dry premises 
with temperature not going below +5ºC.
We recommend unscrewing of wheels during transpor-
tation, which will prevent the lawnmower from moving 
freely. When transporting the lawnmower on longer 
distances or when forwarding thereof, dismantling and 
placing of lawnmower into the manufacturer’s packing 
(box) is advised.

TROUBLESHOOTING

Failure Cause/solution

Failure

The machine fails 
to operate

Machine functions 
intermittently

Mowing resuit is 
irregular/rough

Cause/solution

Machine is not switched on 
correctly /see chapter 4. USE 
Extension cable damaged/
inspect cable, replace if 
damaged
Extension cable damaged/
inspect cable, replace if 
damaged. Machines internal 
wiring damaged /contact 
service centre 
Check mowing-height 
(wheels)/see Chapter 3. 
ASSEMBLY Cutting blade is 
blunt/Inspect blade, sharpen or 
replace the blade 

Machine vibrates 
excessively 
Some grass does 
not enter into 
grass réservoir 
(lies on lawn after 
mowing)

Rotating blade is out of 
balance/check blade on 
damages. Grass reservoir is 
full/empty the reservoir before 
continue. The fan (see spare 
parts list; nr.6) is damaged/
replace the fan”. Grass is not 
dry enough/continue mowing 
when grass is dry

Faults

If a fault arises through wear in an element, please con-
tact the service address shown on the warranty card. 
A drawing of the spare parts that may be obtained is 
included at the end of these operating instructions.

ENVIRONMENT

To prevent damage during transport, the appliance is 
delivered in a solid packaging which consists largely of 
reusable material. Therefore please make use of op-
tions for recycling the packaging.

WARRANTY

Read the terms of warranty on the separate warranty 
card which is enclosed. Please contact the service ad-
dress if you have any questions regarding accessories 
and/or batteries.

is equipped with a reservoir for the collection of mowed 
grass, the so-called bag, relieving of the necessity to 
rake. NB: mowing of humid plants results in a signi

fi

 -

cant decrease in ef

fi

 ciency of grass collection in the 

bag.

ATTENTION! 

•  Do not mow wet grass with the lawnmower! 
•  Select the desired height of mowing before start-

ing up the appliance. All wheels shall be set on the 
same level. Wheel axles shall be screwed on prop-
erly. A loose wheel may fall under a rotating knife. 

•  Running over the electric cord on the ground with 

the operating lawnmower is prohibited. To prevent 
running over the cord, we recommend hanging it on 
the shoulder of the lawnmower’s operator. 

•  Push the lawnmower carefully or drag it before your-

self whenever operating the appliance. 

•  Start the motor up after the connection of the exten-

sion cord only. 

• Over

fi

 lling of glass reservoir is not recommended. 

•  Do not mow if the grass bag has not been arranged 

and the rear cover is lifted, which may 

RESULT

IN INJURY

!

Observe all the above-mentioned requirements care-
fully. Start mowing from the place closest to the power 
source (

fi

 g. 3).

5. SERVICE & MAINTENANCE

WARNING!

 Unplug the electric cable (power 

source) prior to any maintenance or prepara-
tory storage operations. 

Cleaning

Grass or soil residues shall be removed with a brush 
and wooden trowel. Clean the housing regularly with 
a soft cloth, preferably every time it is used. Remove 
stubborn dirt with a soft rag moistened in soapy water. 
Do not use any solvents such as petrol, alcohol, am-
monia, etc. as such substances can damage the plastic 
parts. 

ATTENTION

! Washing of the lawnmower un-

der a sheet of water is prohibited - the water-
tightness of the body secures the IP 34 class 

only (is not entirely water-tight)!

Maintenance

Inspect the wear-out of main units periodically. Deterio-
ration in mowing quality, detected after a certain period 
of time, may signify that the blade of the lawnmower 
has got blunt.
The following regulations shall be observed for the 
sharpening of blade: 
•  the blade shall be cooled constantly during sharpen-

ing to prevent inadmissible overheating 

•  the blade shall be sharpened evenly on all sides to 

prevent vibration of the blade during operation 

•  if you note any cracks or slits, the blade shall be re-

placed with a new one (as well as in the case where 
the area of the blade decreases by over 5 millim-
eters during sharpening)