Kuppersberg HGG 663 T - Инструкция по эксплуатации - Страница 13

13

English

TEchnical passporT

gas oven

CONVERSIONS 

BURNERS

GAS

NORMAL

PRESSURE

mbar

NORMAL

RATE

INJECTOR

DIAMETER

1/100mm

NOMINAL HEAT 

INPUT (W)

№

DESCRIPTION

g/h

Min.

Max.

1

OVEN

BUTANE G30

PROPANE G31

28-30

37

174

171

78(C)

78(C)

1100

1100

2400

2400

2

GRILL *

BUTANE G30

PROPANE G31

28-30

37

160

157

73

73

–

–

2200

2200

Maintenance And Cleaning
CLEANING

Always allow the appl’ance to cool 

down before cleaning to avoid a burn 

injury Do not use caustic or abrasive 

agents, coarse wire wool or hard tools as 

these can damage the surface fi nishes.

Normally, wiping with a soft cloth 

dampened with hot detergent is 

suffi cient,  but  for  stubborn  marks  the 

following is recommended;

Vitreous Enamel Parts

Use only a cleaner thet is 

recommended for this type of 

metarialavoid chloride-based products 

such as bleach.

Door Glass

Do not use any abrasive medium 

thet could cause damage, Rem ember 

that if the surface of the glass panel 

becomes scratched, this could lead to a 

dangerous failure.

To facilitate cleaning, the door glass 

can be lifted out after removing the 

fi xing screws, Whwn refi tting, make sure 

that the glass is correctly seated in the 

door recess and the correct way round.

Cane must be taken when cleaning 

between the door glasses, and inside 

the inner frame as some of the edges 

maybe sharp due to the manufacturing 

process.

WARNING

Â

Take care not to dislodge the 

hinge lock system when removing the 

door as the hinge mechanism has a 

strong spring system!

Â

Do not immerse the door in 

water at any time.

Changing the Oven Bulb 
Caution

To  change  the  bulb,  fi rst  ensure 

that the oven is disconnected from the 

power supply. 

Â

Unscrew the lens from the lamp 

holder.

Â

Exchange the bulb and replace 

the lens. The replacement bulb must 

300“C These can be ordered from the 

Technical Service Department.

TABLE