Elica TONDA WH F/60 - Инструкция по эксплуатации - Страница 12

12 

cooking fumes or odours is particularly strong (for 
example when frying, cooking fish etc.).  

The fast speed will run for about 5 minutes and then 
return to the speed previously set automatically (1, 2 or 
3), or switch off if no speed was selected.  

To turn off the fast speed, before the end of the 5 
minutes, press button 1 or button 2. 

8.   OFF lamp button 
9.  ON lamp button 
 
If the hood fails to operate correctly, briefly disconnect it from 
the mains power supply for almost 5 sec. by pulling out the 
plug. Then plug it in again and try once more before 
contacting the Technical Assistance Service. 

Maintenance 

ATTENTION!  Before performing any maintenance operation, 
isolate the hood from the electrical supply by switching off at 
the connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and 
socket, then the plug must be removed from the socket. 

Cleaning 

The cooker hood should be cleaned regularly (at least with the 
same frequency with which you carry out maintenance of the 
fat filters) internally and externally.  Clean using the cloth 
dampened with neutral liquid detergent. Do not use abrasive 
products. DO NOT USE ALCOHOL! 
WARNING:  Failure to carry out the basic cleaning 
recommendations of the cooker hood and replacement of the 
filters may cause fire risks.  
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage to 
the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 

Grease filter 

Traps cooking grease particles.  
If situated inside the support grill, it may be one of the 
following types:  
Paper filter  must be replaced once a month or if colouring 

appears on upper side, in such cases the colouring is evident 
through the grill openings.  
Sponge filter  should be washed with hot soapy water once a 

month and replaced every 5 to 6 washes.  
Metallic filter must be cleaned once a month, with non 

abrasive detergents,  by hand or in dishwasher on low 
temperature and short cycle.   
When washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To access the grease filter J open the suction grill H via the 
release hooks L and free from the supports K. 
Some models are provided with a metallic filter M without 
support grill, these should be washed as described above 
and removed from their housing by pressing the N handles 
towards the bottom.  

Charcoal filter (filter version only) 

It absorbs unpleasant odours caused by cooking. 
The saturation of the activated charcoal occurs after more or 
less prolonged use, depending on the type of cooking and the 
regularity of cleaning of the grease filter. 
In any case it is necessary to replace the cartridge at least 
every four mounths (or when the filter saturation indication 
system – if envisaged on the model in possession – indicates 
this necessity). 
Carbon filter with central handle 
Apply one on each side as cover to both the shield grids of the 
motor impeller, then turn the P central handle of the filters 
clockwise. 
For the disassembly, turn the P central handle of each filter 
counter-clockwise. 

Replacing lamps 

Disconnect the hood from the electricity. 
Warning!  Prior to touching the light bulbs ensure they are 
cooled down. 
Replacing lightbulbs 40W - Access the light compartment - 
Remove the fixing screws of the light shield. Unscrew the 
damaged light bulb and replace with an incandescent oval 
light bulb with a maximum of 40W E14. 
 
Replacing the halogen bulbs - Access the light compartment 
– extract the lamp cover by levering it off with a small 
screwdriver or similar tool. 
Replace the damaged light bulb. Only use halogen bulbs of 
20W max (G4), making sure you do not touch them with your 
hands. Close the lamp cover (it will snap shut). 
(Z1 - Z2) 
If the lights do not work, make sure that the lamps are fitted 
properly into their housings before you call for technical 
assistance.