Gorenje GBFU150EDDB6 - Инструкция по эксплуатации - Страница 20

20

Manual temperature setting:

-  Use the  

  key and select the   operating mode (yellow control lamp under   is on).

-  The display always shows the last setting of the water temperature; except on first turn on 

of appliance when  factory setting 35ºC is displayed.

-  Use the  

  or   

  key to select new temperature. By pressing the key you increase/

decrease the temperature by 1ºC. Holding the key will speed up the process. 

-  After required temperature is set display flashes for 3 seconds and then shows the current 

temperature again.

-  In case of interruptions in power supply, the appliance resumes operating with the settings 

adjusted before the interruption. 

INDICATION:

•  Control lamps:

- 

Heating element  operation  

:  

Green control lamp:

- 

the heating element  is on – the lamp is  on

- 

the heating element  is off – the lamp is  off

- 

Mg anode  

:

  Red control lamp:

- 

the lamp is off

– anode is active 

- 

the lamp is on – anode may be worn out

Warning! 

When the water heater is out of use for longer 

period of time, the signal lamp may indicate that the 

Mg anode is worn out in spite of the fact that the Mg 

anode is still active. In this case open the hot water tap 

(fresh water flow into water heater). If the signal lamp 

switches off, the water heater operation is not impaired. 

If not, call the nearest authorized service provider

- 

Water heater operation

: 

Yellow control lamps:

- 

protection against freezing – the lamp is on or

- 

cost saving temperature setting – the lamp is on or

- 

manual setting– the lamp is on

•  LED display:

- 

Water temperature of in the heater

: 

from 0ºC to 75ºC

- 

When set, display of  the adjusted temperature

:  

(flashing from 0ºC to 

75ºC)

- 

Error indication

: 

- 

display 

E1 

–

failure  of  the  electronic  regulator  sensor  (the 

heating element doesn’t operate)

- 

display 

E2 

-

failure of the thermometer sensor (water heater 

operates)

- 

display 

E3

  -

failure  of  both  sensors  (water  heater  doesn’t 

operate)

EN