Винные шкафы Dunavox DX-7.20BK/DP - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Code Rev. D 20140818 (IEC)
19
The door is not closed completely.
The door gasket does not seal properly.
Close door properly.
Check the door seal and clean or
replace.
The light does not
work.
Appliance is not connected to a power
supply.
The circuit breaker tripped or a blown fuse.
The light was switched off on the control
panel.
Connect the appliance.
Switch on circuit breaker or
replace fuse.
Switch on the light.
Vibrations.
The appliance is not properly level.
Level the appliance with the
adjustable feet.
The appliance
seems to make too
much noise.
The rattling noise may come from the flow of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls may
cause popping and cracking noises.
The appliance is not properly level.
Level the appliance with the
adjustable feet.
The door will not
close properly.
The appliance is not properly level.
The door was reversed and not properly
installed.
The gasket is dirty.
The shelves are out of position.
Level the appliance with the
adjustable feet.
Check the door hinge and
reassemble correctly.
Clean the door gasket.
Check the shelves and refit
correctly.
Display “E0”, “E1”.
“E2”, “E3”, “E4”,
“E5”, “E6” or “E7”.
“E0” indicates the communication error for 3
zone models.
“E1” or “E2” indicates that the air
temperature sensor is failed.
“E3” or “E4” indicates that the defrost
sensor in the evaporator is failed.
“E5” indicates the defrost heater failure.
“E6” indicates the solenoid valve failure.
“E7” indicates the door switch failure.
Call for service.
The alarm sounds
and the
temperature
display flashes.
Has the appliance door been open for longer
than 60 seconds? If not, then the
temperature has risen higher or fallen lower
than the temperature that has been set. This
could be due to:
The appliance door being opened too often.
The ventilation opening being covered or too
dusty.
A lengthy interruption to the power supply.
A large amount of bottles has been added to
the unit.
If yes, close the door.
Do not open the door more often
than necessary.
Clear the obstructions and clean
the dust.
Leave the appliance to work for a
while until the set temperature
has been reached.
The icon
“--” is lit
up and flashing in
the temperature
display.
The display temperature is out of the range.
Only temperatures within the
range 0~99
°F/-9~37°C the
appliance can display will be
shown. If the temperature is not
within this range, the icon
“--” will
be displayed instead. That is
normal.
WARRANTY
The statutory warranty period applies. If the product is defective, please contact your local distributor.
In case you need any services, please include the following documents when you send in the device:
A copy of the receipt with purchasing date.
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
