Sony DCR-PC9E - Инструкция по эксплуатации - Страница 206

206

If you run into any problem using your camcorder, use the following table to troubleshoot the
problem. If the problem persists, disconnect the power source and contact your Sony dealer. If
“C:

ss

:

ss

” appears on the screen, the self-diagnosis display function has worked. See page 213.

I n  t h e  r e co r d i n g  m o d e

Sympt om

Cause and/ or Correct ive Act ions

• The POWER switch is not set to CAMERA.

c

Set it to CAMERA (p. 30).

• The tape has run out.

c

Rewind the tape or insert a new one (p. 27, 50).

• The write-protect tab is set to expose the red mark.

c

Use a new tape or slide the tab (p. 27).

• The tape is stuck to the drum (moisture condensation).

c

Remove the cassette and leave your camcorder for at least  1
hour to acclimatize (p. 234).

• While being operated in CAMERA mode, your camcorder has

been in the standby mode for more than 5 minutes.

c

Set the POWER switch to OFF (CHARGE) and then to
CAMERA (p. 30).

• The battery pack is dead or nearly dead.

c

Install a fully charged battery pack.

• Viewfinder is not extended to the end.

c

Pull out the viewfinder.

• The viewfinder lens is not adjusted.

c

Adjust the viewfinder lens (p. 36).

• STEADYSHOT is set to OFF in the menu settings.

c

Set it to ON (p. 134).

• The setting is the manual focus mode.

c

Press FOCUS to set to the auto focus mode (p. 76).

• Shooting conditions are not suitable for autofocus.

c

Adjust to focus manually (p. 76).

• The LCD panel is open.

c

Close the LCD panel (p. 33).

• The contrast between the subject and background is too high.

This is not a malfunction.

• This is not a malfunction.

• Slow shutter, low lux or Super NightShot mode is activated.

This is not a malfunction.

START/STOP does not operate.

The power goes off.

The image on the viewfinder screen
is not clear.

The picture does not appear in the
viewfinder.

The autofocusing function does not
work.

The SteadyShot function does not
work.

A vertical band appears when you
shoot a very bright subject.

Some tiny white spots appear on the
screen.

A vertical band appears when you
shoot a subject such as lights or a
candle flame against a dark
background.

— Tr o u b l e sh o o t i n g  —

En g l i sh

Ty p e s o f  t ro u b l e  a n d  t h e i r  so l u t i o n s