Велокомпьютеры VDO Z3 PC - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
25
INSTRUCTION MANUAL
11. OPERATION MODE
11.1. An overview of mode functions is provided in section 1.3.1.
11.2 FAST PAIRING after transmission interruption
If no signal is received from one of your already paired transmitters for
more than 15 minutes (e.g. cycling without pulse-chest belt, magnet
moved unintentionally) the receive channel for this transmitter will
be closed. In this case your VDO computer will show dashes for the
respective function in the display. To re-open all receive channels press
the ç and ¥ buttons at the same time:
In this case your VDO computer will then receive all paired transmitters
that are in range. See also chapter 15 Sleep mode
11.3. GETTING STARTED - quick overview
Functions/operation/reset/max values
11.3.0. PERMANENT FUNCTIONS
The following functions are permanently shown in the display:
HEADER
- Actual altitude
- Actual temperature
- Actual ascending gradient in percent ! Not in walk mode !
CENTER BAR
- Heart rate receive icon if the pulse transmitter belt is worn
- Beeper icon if the beeper is switched on
- Stopwatch icon if the timing function is running
- Actual heart rate
- Actual speed: Maximum value 120 km/h or mph (! not in walk mode !)
- Comparison of actual speed to average speed = above, =below
(! not in walk mode !)
- Selected wheel size 1 or 2
- REC for ongoing recording
FOOTER
- Shows selected information and corresponding value
ALTITUDE FUNCTIONS
(button ¥ )
Re-calibrating the air pressure to home altitude. Short-cut press the ¥
button for 4 seconds.
11.3.1. ¬ £ ALTI UP = uphill altitude gain for the actual trip
Display
¥ ALTI
UP
Reset: 3 sec.
√
TRIP DATA ?RESET?
‚
TRIP DATA ?RESET? <<?RESET?
>>
fl
ashing
‚
TRIP DATA RESET DONE
L
Automatic return to operation mode for TRIP DIST
11.3.2. ¬ DIST UP = uphill distance of the actual trip
Display
¥ DIST
UP
Reset: 3 sec.
√
TRIP DATA ?RESET?
‚
TRIP DATA ?RESET? <<?RESET?
>>
fl
ashing
‚
TRIP DATA RESET DONE
This resets all data of the functions marked by
L
Automatic return to operation mode for TRIP DIST
This resets all data of the functions marked by
L
.
HOME
AL
TITUDE
