Vestel VH64E352B - Инструкция по эксплуатации - Страница 34

EN - 14

pressing  , a Cooking Zone Indicator will 

flash for the timer it is assigned to. If no 

Cooking Zone Indicator flashes, the minute 

minder timer value will be shown on the 

Timer Display.

All heater timers can be removed by 

switching the appliance to S-Mode using 

, however this will have no effect on the 

minute minder timer which will continue 

counting down.

To remove a timer in Operation Mode, 

first select the timer using the Activate/

Deactivate Timer button until the desired 

timer is displayed on the Timer Display. It 

can then be removed in two ways:

• Decrease the value by using the slider

button until “

00

” is shown on the Timer

Display

• Press the right and left sides of the

slider button simultaneously until “

00

” is

shown on the Timer Display

Once a timer reaches “

00

”, the level of 

its corresponding heater will also set to 

“

0

”. The end of both the heater timer and 

the minute minder timer is indicated by 

a buzzer sound, this can be stopped by 

pressing any button.

Key Lock

The key lock function is used to set ‘safe 

mode’ on the appliance and can only be 

used in Operating Mode (B-Mode). The lock 

function becomes active when the Key Lock 

button   is pressed for at least 2 seconds. 

This operation is acknowledged by a buzzer 

and the Key Lock Indicator will flash to 

indicate the heater will be locked.

If the heater is locked, it will only be 

possible to switch the appliance off by 

pressing    , all other buttons are blocked 

and it will not be possible to make any 

adjustments by pressing the buttons. If any 

other button is pressed in the lock mode, 

the buzzer will sound and the Key Lock 

Indicator will flash.

Only the switch-off operation by pressing 

 is possible. However, if the appliance is 

switched off, it can not be restarted again 

without being unlocked.

Press   to deactivate the Key Lock 

function, the Key Lock Indicator will 

disappear. The hob controls can now be 

operated as normal.

Child Lock

The Child Lock function is used to lock 

the appliance in a complicated multi-step 

process. Child lock (and unlocking) is only 

available in the S-Mode.

First,   must be pressed until the buzzer 

sounds, then simultaneously press the right 

and left sides of the slider button for at least 

0.5 seconds, but no longer than 1 second. 

Following this, press the right side of the 

slider button only to activate the child lock. 

All four heater displays will show “

L

” as 

confirmation.

If the minute minder timer is still running, 

it will proceed until “

00

” is reached and 

the timer will sound. After confirmation of 

timer completion, the appliance will be fully 

locked. None of the buttons can be used as 

long as the appliance is locked.

Child lock can be deactivated by pressing 

 until the buzzer sounds. Then press 

the left and right sides of the slider button 

simultaneously for at least 0.5 seconds, 

followed by pressing the left side of the 

slider button only. As confirmation for 

successful unlocking, “

L

” will no longer be 

displayed.

Stop & Go

The Stop & Go function is used for pausing 

the operation of the heaters during use. If 

the Stop & Go button   is pressed while 

the heaters are in operation, all the heaters 

will switch off. Pressing   for a second 

time, will switch all the heaters back on.

Touch Control Safety Functions 

The following safety functions are available 

to avoid unintended operations.

Sensor Safety Cut-Off

Button monitoring is included to prevent the