Vestel VH64E352B - Инструкция по эксплуатации - Страница 28

EN - 8

when needed.

2. INSTALLATION AND

PREPARATION FOR USE

WARNING :

 This appliance must be 

installed by an authorised service 

person or qualified technician, 

according to the instructions in this guide 

and in compliance with the current local 

regulations.

• Incorrect installation may cause harm

and damage, for which the manufacturer

accepts no responsibility and the

warranty will not be valid.

• Prior to installation, ensure that the local

distribution conditions (electricity voltage

and frequency and/or nature of the gas

and gas pressure) and the adjustments

of the appliance are compatible. The

adjustment conditions for this appliance

are stated on the label.

• The laws, ordinances, directives and

standards in force in the country of use

are to be followed (safety regulations,

proper recycling in accordance with the

regulations, etc.).

Instructions for the Installer

General instructions

• After removing the packaging material

from the appliance and its accessories,

ensure that the appliance is not

damaged. If you suspect any damage,

do not use it and contact an authorised

service person or qualified technician

immediately.

• Make sure that there are no flammable

or combustible materials in the close

vicinity, such as curtains, oil, cloth etc.

which may catch fire.

• The worktop and furniture surrounding

the appliance must be made of

materials resistant to temperatures

above 100°C.

• If a cooker hood or cupboard is to be

installed above the appliance, the safety

distance between cooktop and any

cupboard/cooker hood should be as

shown below.

HOB

Minimum 

42 cm

Minimum 

42 cm

Minimum  65 cm (with 

hood)

Minimum 70  cm (without 

hood)

• The appliance should not be installed

directly above a dishwasher, fridge,

freezer, washing machine or clothes

dryer.

• If the base of the appliance is accessible

by hand, a barrier made from a suitable

material must be fitted below the base

of the appliance, ensuring 

that there is

no access to the base of the 

appliance

.

2.1 inStallation of the hob

The appliance is supplied with an 

installation kit including adhesive sealing 

material, fixing brackets and screws.

• Cut the aperture dimensions as

indicated in the figure. Locate the

aperture on the worktop so that, after

the hob is installed, the following

requirements are followed.

B (mm)

590

min. A (mm)

50

T (mm)

520

min. C (mm)

50

H (mm)

41-47.5

min. E (mm)

500

C1 (mm)

560

min. F (mm)

10

C2 (mm)

490

G (mm)

20

D (mm)

50

I (mm)

25

J (mm)

5