Fulgor Milano FSH 905 ID TS BK - Инструкция по эксплуатации - Страница 27

27

GB

timer is running, while the dot is static while 
the timer is selected and thus modifiable.

Independent timer

- If the touch display is on, the independent 
timer can be used by simultaneously 
pressing the + and - buttons. If all the 
cooking areas are in position “0”, this is the 
only timer available. The clock icon (24) will 
turn on and the display will show “0.00”. 
If you do not select any button, the timer 
deactivates within 5 seconds.
-  The time setting (0-1hour.59min) can be 

changed in increments of one minute with 
the + button from 0 to 99.

-  Holding down the + or - button dynamically 

increases the rate of change up to a 
maximum value, without beeps.

-  If the + (or -) button is released, the rate of 

increase (decrease) starts again from the 
initial value.

-  The timer can be set by either continuously 

pressing the + or - buttons or by pressing 
successively (with beeps).

After the timer is set, it begins to count down. 
The expiry of the time is signalled by a beep 
or by the flashing of the timer display, which 
will show “00”.
The beep will not stop until the + or - button 
is pressed. The display stops flashing and 
turns off.

Turning off/changing the timer

- The timer can be changed or turned 

off at any time by turning on the touch 
display again, if no cooking area is 
on, and pressing the + and - buttons 
simultaneously to select the timer. At this 
point, set it to “0” by pressing the - button, 
to turn it off, or by pressing the + button to 
increase the time setting.

- The independent timer remains active 

Deactivating Pause

Once activated, the function can be 
deactivated by pressing the pause button 
(6) again. The LED for the pause setting 
turns off and, within 10 seconds, you must 
slide your finger along the cursor below 
the illuminated area (from left to right). 
This allows the surface to resume cooking 
and the timer starts from the same point at 
which it was stopped.

Timer function

There are two versions of the timer function:
- An independent timer from 1 to 59 

minutes: it beeps when the time has run 
out. This function is always available 
and is indicated by the clock symbol 
(24) which is located between the - and 
+ buttons (the symbol may be less bright 
if another cooking area timer has a 
remaining time that is less than that set 
on the independent timer).

-  A timer from 1 to 59 minutes for each 

cooking area: it beeps when the time has 
run out and turns off the cooking area 
where it was set. The 5 cooking areas 
can be programmed independently (the 
symbol may be less bright if another 
cooking area timer has a remaining 
time that is less than that set on the 
independent timer).

The type of timer activated is shown in 
the dedicated displays (19-20-21-22). The 
timer with the least time is highlighted and 
the related clock icon is brighter (13-24). 
The other timer settings are still active and 
running, but the clock icon (13-24) will be 
less bright.
Another icon with the word “min” (23) 
appears when you set times longer than 
10 minutes. For example 0.11 indicates 0 
hours and 11 minutes.
The separator dot (21) flashes when the