Ardesto IR-C2230 - Инструкция по эксплуатации - Страница 19

19

UA

EN

- Fill the reservoir up to the maximum level indicated and set the steam 

selector (D) to “0FF”. 

- Set the thermostat knob (I) to the maximum temperature and wait for the

light (G) to turn off.

- Pull the plug out of the socket and hold the iron horizontally over the sink.

- Hold the cleanout button (J) setting until all the boiling water, steam,

impurities come out 

[Fig. 7]

.

- When the soleplate has cooled down, you can clean it with a damp cloth.

AFTER THE IRONING

- Disconnect the plug of the iron from the socket.

- Empty the reservoir by turning the iron upside down and

  gently shaking it.

- Leave the iron to cool down completely.

- Roll up the power cord with the rewinder 

[Fig. 8]

.

- Always store the iron in a vertical position.

ADVICE FOR GOOD IRONING

We recommend using the lowest temperatures with fabrics that have 

unusual finishes (sequins, embroidery, flush, etc.).

If the fabric is mixed (e.g. 40% cotton 60% synthetics), set the thermostat to 

the temperature of the fibre requiring the lower temperature.

If you don’t know the composition of the fabric, determine the suitable 

temperature by testing on a hidden corner of the garment. Start with a low 

temperature and increase it gradually until it reaches the ideal temperature.

Never iron areas with traces of perspiration or other marks: the heat of the 

plate fixes the stains on the fabric, making them irremovable.

The size is more effective if you use a dry iron at a moderate temperature: 

excess heat scorches it with the risk of forming a yellow mark.

To avoid marking silk, woolen or synthetic garments shiny, iron them inside out. 

To avoid marking velvet garments shiny, iron in one direction (following the 

fibre) and do not press down on the iron.