Ardesto IR-C2230 - Инструкция по эксплуатации - Страница 17

17

UA

EN

Start ironing the garments requiring a low temperature.

This reduces the waiting times (the iron takes less time to heat up than to 

cool down) and eliminates the risk of scorching the fabric.

STEAM IRONING

Filling the reservoir

- Check that the plug is disconnected from the socket.

- Move the steam selector (D) to «0» 

[Fig. 1]

.

- Open the lid (C).

- Raise the tip of the iron to help the water enter the opening without 

overflowing.

- Slowly pour the water into the reservoir using the special measure (18)

and taking care not to go over the maximum level (about 280ml) indicated 

by 

«MAX»

 on the reservoir 

[Fig. 2]

.

- Close the lid (C).

SETTING THE TEMPERATURE

- Put the iron in a vertical position.

- Put the plug in the socket.

- Adjust the thermostat knob (I) according to the international symbol on 

the garment label

 [Fig. 3]

. The plate temperature control light (G) indicates 

that the iron is heating up. Wait until the plate temperature control light 

goes off before ironing.

Warning:

during ironing, the plate temperature control light (G) comes on at 

intervals, indicating that the selected temperature is maintained. If you lower 

the thermostat temperature after ironing at a high temperature, do not start 

ironing until the plate temperature control light comes on again.

SETTING THE STEAM

The quantity of steam is regulated by the steam selector (D).

- Move the steam selector to a position between minimum and maximum

depending on the quantity of steam required and the temperature 

selected 

[Fig. 1]

.

Warning:

the iron gives off steam continuously only if you hold the iron 

horizontally. You can stop the continuous steam by placing the iron in a 

vertical position or by moving the steam selector to “0FF”. As indicated on 

the thermostat knob (I) and in the initial table, you can only use steam at the