Ryobi RBC1226i 5133002506 - Инструкция по эксплуатации - Страница 4

2

| English

or H05 VV-F”. Check it before every use 
for damage. Always uncoil it during use 
because coiled cables can overheat. 
Damaged extension cables should not be 
repaired; they should be replaced with an 
equivalent type.

■

Do not use the product if the electric cables 
are damaged or worn.

■

If the power cord or extension cable 
becomes damaged during use, disconnect 
from the power supply immediately. Do not 
touch the electric cables until the power 
supply has been disconnected. 

■

Make sure the power cord is positioned so 
that it cannot be damaged by the cutting 
means and will not be stepped on, tripped 
over or otherwise subjected to damage or 
stress.

■

Never pick up or carry the product by the 
power cord.

■

Never pull by the power cord to disconnect 
from the power supply.

■

Keep the power cord away from heat, oil 
and sharp edges.

■

Make sure the voltage is correct for the 
product. A nameplate on the product 
indicates the product’s voltage. Never 
connect the product to an AC voltage that 
differs from this voltage.

■

Make sure the switch is in Off position 
before disconnecting from power supply.

PREPARATION

■

Wear full eye and hearing protection while 
operating the product. If working in an area 
where there is a risk of falling objects, head 
protection must be worn.

■

Hearing protection may restrict the 
operator’s ability to hear warning sounds. 
Pay particular attention to potential hazards 
around and inside the working area.

■

Wear heavy long trousers, boots, and 
gloves. Do not wear loose fitting clothing, 
short trousers, jewellery of any kind, or use 
with bare feet.

■

Secure long hair so it is above shoulder 
level to prevent entanglement in moving 
parts.

■

Before use and after any impact, check that 
there are no damaged parts. A defective 
switch or any part that is damaged or worn 
should be properly repaired or replaced by 
an authorised service facility.

■

Make sure the cutting attachment is 
properly installed and securely fastened.

■

Never operate the product unless all 
guards, deflectors and handles are properly 
and securely attached.

■

Consider the environment in which you are 
working. Keep the working area free from 
wires, sticks, stones and debris, which if 
struck by the cutter, can become thrown 
objects.

GENERAL SAFETY WARNINGS

 WARNING

Read all safety warnings and all 

instructions.

 Failure to follow the warnings 

and instructions may result in electric shock, 

fi

 re and/or serious injury.

Save all warnings and instructions for 

future reference

.

The term “power tool’’ in the warnings refers 

to your mains-operated (corded) power tool or 

battery-operated (cordless) power tool.

WORK AREA SAFETY

■

Keep work area clean and well lit.

Cluttered or dark areas invite accidents.

■

Do not operate power tools in explosive 

atmospheres, such as in the presence 

of flammable liquids, gases or dust.

Power tools create sparks which may ignite 

the dust or fumes.

■

Keep children and bystanders away 

while operating a power tool.

 Distractions 

can cause you to lose control.

ELECTRICAL SAFETY

■

Power tool plugs must match the outlet. 

Never modify the plug in any way. Do 

not use any adapter plugs with earthed 

(grounded) power tools.

 Unmodified 

plugs and matching outlets will reduce risk 

of electric shock.

■

Avoid body contact with earthed or 

grounded surfaces, such as pipes,