Hitachi CG 40 EYA (TP) - Инструкция по эксплуатации - Страница 14

GB-12

NOTE!

Press the quick release button or pull emergency 
release flap (If so equipped) in the event of 
emergency. (Fig. 2-4C)

Stopping (Fig. 2-5)

   Decrease engine speed and run at an idle for
   a few minutes, then turn off ignition switch.

      WARNING!
A cutting attachment can injure while it 
continues to spin after the engine is stopped 
or power control is released. 
When the unit is turned off, make sure the 
cutting attachment has stopped before the unit 
is set down.

When cutting, operate engine at over 6500 rpm. 
Extended time of use at low rpm may wear out 
the clutch prematurely.
Cut grass from right to left.
Blade thrust may occur when the spinning blade 
contacts a solid object in the critical area. 
A dangerous reaction may occur causing the 
entire unit and operator to be thrust violently.
This reaction is called BLADE THRUST. As a 
result, the operator may lose control of the unit 
which may cause serious or fatal injury. Blade 
thrust is more likely to occur in areas where it 
is difficult to see the material to be cut.
Wear the harness as shown in the figure (if so 
equipped). The blade turns counter-clockwise, 
therefore, be advised to operate the unit from 
right to left for efficient cutting. Keep onlookers 
out of working area at least 15 m (50 ft.).

Cutting (Fig. 2-4, 4B, 4C, 4D)

Fig. 2-4

Fig. 2-4B

Fig. 2-4C

      WARNING!
If cutting attachment should strike against 
stones or other debris, stop the engine and 
make sure that the attachment and related 
parts are undamaged. When grass or vines 
wrap around attachment, stop engine and 
attachment and remove them.

Fig. 2-4D

Fig. 2-5

15m