Телефоны Elenberg CLPD-6010 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
27
Caller-ID
NO DISPLAY
• Is the battery fully charged? Try to replace the batteries.
• Make sure that the base is connected to a non-switched AC outlet.
Disconnect the base from the plug and plug it in again.
• Have you subscribed to the Caller ID service from your local tele-
phone company? The display will not work unless you do this.
Telephone
NO DIAL TONE
• Check installation:
- Is the base power cord connected to a working outlet?
- Is the telephone line cord connected to the base unit and the wall
jack?
- Disconnect the base from the wall jack and connect another to
the same jack. If there is no dial tone in the second phone, the
problem might be your wiring or local service.
- Is the handset out of range of the base?
- Make sure the batteries properly charged (at least 16 continuous
hours).
- Are the batteries installed properly?
- Did the handset beep when you press the ? Did the CHARGE
indicator come during battery charging? The batteries may need
to be charged.
PHONE BEEPS
• If it does not work, charge the batteries for 16 continuous hours.
• Replace batteries.
DIALING FROM MEMORY
• Did you program the memories correctly?
Causes of poor reception
• Aluminum siding.
• Foil backing on insulation.
• Heating ducts and other metal construction can shield radio signals.
• You are too close to appliances such as microwaves, stoves, com-
puters etc.
• Atmospheric conditions, such as storms.
• Base is installed in the basemen or lower floor of the house.
• Handset batteries are low.
• You are out of range of the base.
TROUBLE-SHOOTING
