Телефоны Elenberg CLPD-6010 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
25
Select Ringer Tones
1. To enter the Ringer tone selection, press the “P” and then the [5] key.
There are 6 different ringer melodies selectable via the [1] to [6] keys.
The handset ringer will provide the respective ringing melody when
any of these keys is pressed.
2. Press “P” when the required melody is selected.
Select Ringer Volume
1. To enter the ringer volume selection, press the “P” and then the [6]
key. There are 3 ringer volume levels, low, medium and, high levels,
selectable via the [1], [2] and [3] keys.
2. Press “P” key to store the setting.
Key Lock Mode
You can lock the keypad to prevent keys from accidentally being pressed.
To lock the keypad:
1. Long press key and the key icon will be displayed.
2. To unlock, long press key again. When the handset is unlocked, the
key icon will disappear on the display.
Note: Key lock is disabled in the event of an incoming call, but return to
key lock when the call ends.
System PIN number
The Elenberg DECT has built-in a system PIN which is used for prevent-
ing misuse of certain features or accidental mis-programming of certain
features such as Baby Mode (described in the previous section). The fac-
tory default setting for the Pin Number is 0000. You can change it to any
other four digits you can remember easily. If you forget it, please consult
your nearest Service Centre.
To change the PIN number proceed as follows:
1. Press “P” and then [1] key.
2. The screen shows “____” to prompt you to input
the current PIN (factory default is 0000).
3. Enter the current PIN number then followed by “P” key.
4. The “____” will be shown again.
5. Enter the new 4 digit numeric PIN followed by “P” key.
6. The “____” will be shown again.
7. Enter the new 4-digit numeric PIN followed by “P” key again for re-
confirmation.
Tone or pulse dialing mode
To change the dialling mode, press “P” and [*] will enter the dial mode
selection operation.
The display will show “P-”.
Press [1] to enter the pulse mode or press [2] to stay in tone mode, then
press “P” to confirm.
HANDSET SETTING
