Karcher WD 3 P-I (1.629-891.0) - Инструкция по эксплуатации - Страница 11

– 7

Illustration 



The cartridge filter must always be installed - with 

wet and dry vacuuming.

Note

: Let the wet cartridge filter dry prior to using it for 

dry vacuuming.

Illustration 



Push the suction hose into the connection on the 

appliance, it snaps in place.



In order to disconnect it, push down with your 

thumb and pull the suction hose out.

Note:

 Accessories, such as suction brushes (optional) 

can be directly attached to the connecting piece and 

thus connected to the suction hose.

For convenient working even in tight spaces.

The removable handle can be attached between the ac-

cessories and the suction hose if necessary.

See position 14.

Recommendation:

 In order to vacuum the floor, attach 

the handle to the suction hose.

Illustration 



Connect the handle with the suction hose until it 

snaps in place.

Illustration 



To remove the handle from the suction hose, press 

the notch using your thumb and pull off the handle.

Note:

 Due to removing the handle, accessories can be 

directly attached to the suction hose. 

Recommendation:

 In order to vacuum the floor, attach 

the handle to the suction hose.

See position 13.

Illustration 



Put both suction tubes together and connect them 

with the handle.



For edges, joints, heaters and hard to reach loca-

tions.

Illustration 



Note:

 For vacuuming dry dirt or water off the floor - 

always work with the insert (brush strip and rubber 

lip) in the floor nozzle.

Illustration 



To connect the suction hose with an electric tool



Adapt the adapter to the connection diameter of the 

electric tool using a knife if necessary.

ATTENTION

Always work with an inserted cartridge filter during wet 
as well as dry vacuum cleaning!

Illustration 



Mount loose parts delivered with appliance prior to 

start-up.

Illustration 



Connect accessories.

Illustration 



Plug in the mains plug.

Illustration 



Turn on the machine.

ATTENTION

Check the filter for damage prior to installation and re-
place as necessary.
Work with a dry cartridge filter only!

Illustration 



Recommendation

: To vacuum fine dust, use the 

filter bag.

–

The filling level of the filter bag depends on the dirt 

that is sucked in. 

–

The filter bag needs to be replaced more frequently 

while sucking in fine dust, sand, etc.

–

Clogged filter bags can burst - therefore make sure 

to replace the filter bag in a timely manner!

ATTENTION

Vacuum cold ashes only when using a pre-filter.



For vacuuming up moisture or liquids pay attention 

to the correct floor nozzle insert and connect the 

corresponding accessories.

ATTENTION

Do not use a filter bag!

Note: 

If the container is full, a float closes the suction 

opening, and the appliance works at a higher speed. 

Switch off the appliance immediately, and empty the 

container.

Cartridge filter

Suction hose with connecting piece

Removable handle

Suction tubes 2 x 0.5 m

Crevice nozzle

Floor nozzle

(with inserts)

Adapter

Operation

Before Startup

Start up

Dry vacuum cleaning

Information filter bag

Wet vacuum cleaning

11

EN