Oursson JM3300/IV - Инструкция по эксплуатации - Страница 11

11

1. 

 Assemble the device as described in the previous sec

-

tion.

2. 

 Plug the device into an electrical outlet.

3. 

 Turn on the device, turning the knob in «1» or «2» posi

-

tion.  

4. 

 With the help of the pusher place beforehand washed 

and, if necessary, peeled and chopped ingredients into 

the feeding chute.

 Fruit with a large seed, such as 

plum, apricot or peach, remove the seeds before 

making juice from them.

5. 

 After finishing juicing turn it off and unplug it. 

The ingredients must be placed in small portions, to not 

overfill the cup. Use the pusher to push ingredients. In addi

-

tion, the pusher will help avoid splashing the juice from the 

feeding chute, when squeezing juicy products.

At the end of juicing, close the lid of the spout so that 

the remnants of juice do not drip on the table.

TIP:

 It is recommended to drink fresh juices immediately 

after preparation, because after a while they begin to flake, 

lose useful properties and attractiveness.

а

c

b

uTILIZATION

ORDER OF OPERaTION

Before first use,

 wipe the device with a soft, dry cloth. 

The rest of the parts

 wash with warm water and 

detergent. Before assembling or disassembling the 

device and / or removing attachments, make sure 

that the device is unplugged. 

The order of assembly 

Рiс. B.

•  Place the motor unit on a flat and clean surface.

•  Assemble the device according to the picture:

•  Install the filter insertion onto the motor unit

•  Insert filter into the filter insertion

•  Install pulp container

•  Install the lid

• 

Fixate the catch onto the juice maker’s lid.

•  Place under the spout a container for juice, no 

less than 1L capacity 

•  Place the pusher into the feeding chute 

EMPTYING THE PULP CONTaINER aND 
MESH FILTER:

•  Turn off the device, turn the knob to “0” mark.

•  Detach the pulp container form the motor unit. 

Empty the container.

•  Install the pulp container back.

•  Mesh filter must be emptied if:

•  Motor unit’s rotating speed has lowered

•  Juice is too thick

•  The device starts to vibrate

NOTE: 

Pulp container must be emptied before the pulp 

level reaches edge of the tray. It is recommended to empty 

the pulp container and mesh filter at the same time. 

DISaSSEMbLING THE JUICE MaKER:

•  Turn off and unplug the device.

• 

Wait till the motor unit stops, approximately 10 

sec.

•  Remove the pusher and pulp container.

•  Lower the catch and remove the lid. 

•  Remove the mesh filter.

•  Remove the filter insertion from the motor unit.

NOTE: 

If the device begins to vibrate, it means that the 

mesh filter is clogged or damaged. Turn off the device and 

check the mesh filter status. 

Before  opening  the  device,  make  sure  the 

motor unit is fully stopped.

Damaged mesh filter must not be used. 

The  device  is  equipped  with  a  safety  lock.  It 

won’t  be  possible  to  turn  on  the  device  if  the 

catch isn’t fixated on the lid.

To avoid overheating of the motor, do not use 

this device for more than 4 minutes without 
a pause. Every 4 minutes make a 5-minute 

break and let the device cool down.

To push the ingredients into the feeding chute, 

use only the pusher, which is included with the 

device.  It  is  strictly  forbidden  to  push  ingredi

-

ents with hands, as this could cause injury.

Power knob:

«0» – Turn on

«1» – Turn on, low speed

«2» – Turn on, high speed

PREPaRaTION RECOMMENDaTIONS:

1.   Do not place into the device dried or hard ingredi-

ents, such as whole grains, fruits with hard seeds, 

thick-skinned or ice. This can damage juice maker’s 

parts.

2. 

 Do not press the products without juice content 

(coconut, sugar cane, whole grains, etc.).

3.   Do not use ingredients that contain an excessive 

amount of vegetable oil or animal fat. Do not use the 

juice maker for squeezing oil from the ingredients. 

4.   Do not load pulp into the juice maker. 
5. 

 After juicing the ingredients with small seeds, you 

must clean all parts of the device from the seeds.

6. 

 The amount of juice depends on the freshness and 

juiciness of the products. The fresher the vegetables 

or fruit, the more juice you can make.

Ingredients

Preparation 

Speed

Note

Apple (pear, quince, 

etc.)

Medium size fruits may be placed 

without preparation. Big ones-cut. 
Remove the peduncle.

1

Cut the damaged fruit pulp.