Снегоуборщики AL-KO SNOWLINE 760TE - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
GB
Original operating instructions
30
AL-KO snow blowers
If petrol has spilled out:
Do not start the engine
Do not attempt ignition
Collect spilled petrol with a binding agent
or cloth and dispose of appropriately.
Clean the machine
If engine oil has spilled out:
Do not start the engine
Collect spilled engine oil with an oil
binding agent or cloth and dispose of
appropriately.
Clean the machine
When disposing of used oil:
▪
do not throw into the rubbish
▪
do not pour into sewers or drains or onto the
ground
We recommend returning used oil in a
closed container to a recycling facility or
service centre.
Adding engine oil
1. Remove the oil cap (
12 -1
) and store in a
clean location.
2. Add oil using a funnel.
3. Check the oil level.
4. Replace the oil cap tightly and clean.
See the engine manual for information about che-
cking the oil level.
Adding petrol
1. Remove the tank cap (
12-2
) and store in a
clean location.
2. Add petrol using a funnel.
3. Replace the tank cap tightly and clean.
Getting ready for operation
Caution!
Do not operate a damaged machine!
Perform a visual check before using.
The camera symbol on the following pages
refers to the illustrations.
Checking the tyre pressure
Check the tyre pressure before the first use in
winter and at least once every three months du-
ring the period of use.
The maximum allowed tyre pressure is indicated
on the tyres (
11 -1
). Note: 1 bar = approximate-
ly 14.5 psi
Adjusting the clearance height
Danger - risk of injury!
Adjust the clearance height only if the
engine is switched off and the auger is not
in motion!
▪
Adjust the clearance height to avoid taking in
gravel or other objects.
▪
Look out for uneven places such as ruts,
manhole covers or paving stones.
1. Place the machine on an level surface.
2. Loosen the left and right skid plate clamping
screws (
13 -1, 14 -1
).
3. Raise the clearing plate (
13 -2
) to the desi-
red height and attach the skid plates.
4. Make sure that both skid plates are spaced
equally so that the clearing plate runs parallel
to the ground.
▪
If the skid plates are worn
(sliding edge (
15 -1
)
worn through),
turn 180° and use the other side
(
15
).
▪ See the replacement parts list when ordering
replacements.
