Ryobi R18PDBL-220S (5133003436) - Инструкция по эксплуатации - Страница 4

English

2

contributing to Raynaud’s Syndrome.

Ŷ

After each period of operation, exercise to increase 
blood circulation.

Ŷ

Take frequent work breaks. Limit the amount of 
exposure per day.

If you experience any of the symptoms of this condition, 
immediately discontinue use and see your doctor about 
these symptoms.

 WARNING

Injuries may be caused, or aggravated, by prolonged 
use of a tool. When using any tool for prolonged periods, 
ensure you take regular breaks.

KNOW YOUR PRODUCT

See page 80.

1. Keyless 

chuck

2. E-TORQUE 

indicator

3. Hammer/Drill/Screw driving mode selector and 

E-TORQUE selector

4.  Two-speed gear train
5.  Forward/ reverse button
6. Switch 

trigger

7. LED 

light 

8.  Screw driver bit
9. Bit 

storage

10. Battery  port
11. Handle, insulated gripping surface

MAINTENANCE

 WARNING

The product should never be connected to a power supply 
when you are assembling parts, making adjustments, 
cleaning, performing maintenance, or when the product 
is not in use. Disconnecting the product will prevent 
accidental starting that could cause serious injury.

Ŷ

When servicing, use only identical replacement parts. 
Use of any other parts may create a hazard or cause 
product damage.

Ŷ

Avoid using solvents when cleaning plastic parts. Most 
plastics are susceptible to various types of commercial 
solvents and may be damaged by their use. Use clean 
cloths to remove dirt and carbon dust.

Ŷ

Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact 
with plastic parts. They contain chemicals that can 
damage, weaken or destroy plastic.

Ŷ

Always wear safety goggles or safety glasses with side 
shields during power tool operation or when blowing 
dust. If operation is dusty, also wear a dust mask.

Ŷ

For greater safety and reliability, all repairs should be 

performed by an authorised service centre.

LUBRICATION

All of the bearings in the product are lubricated with a 
sufficient amount of high grade lubricant for the life span of 
the product under normal operating conditions. Therefore, 
no further lubrication is required.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing 
of as waste. The machine, accessories and 
packaging should be sorted for environment-
friendly recycling.

E-TORQUE CONTROL

E-TORQUE CONTROL helps regulate the power output 
of the product to avoid over-driving screws and damaging 
materials. To achieve a flush finish, it is best to select a 
low setting before commencing screw driving. When the 
E-TORQUE CONTROL engages, the E-TORQUE selector 
LED and E-TORQUE indicator LED will flash and the 
product will automatically shut down.

If more power is required to drive the screw flush, the 
E-TORQUE CONTROL can be adjusted accordingly. 
E-TORQUE CONTROL only operates in screw driving 
mode, it has no effect on drilling mode.

The product has a memory function that stores torque 
settings. When switching from drilling to screwdriving 
mode, the memory function restores previously used torque 
settings. The E-TORQUE selector and indicator LEDs will 
flash once previously used torque setting is reached.

SYMBOLS

Safety alert

CE conformity

No-load speed

EurAsian Conformity Mark

Please read the instructions carefully 
before operating the product.